Merge git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi-misc-2.6

[linux-2.6-omap-h63xx.git] / drivers / net / e1000 / e1000_hw.c

diff --git a/drivers/net/e1000/e1000_hw.c b/drivers/net/e1000/e1000_hw.c
index 9d6edf3e73f92998d8fb4f19ddbbfe64cd2ca4ac..e1a3fc1303ee9c52d7a3098f1b94e60b230ac210 100644 (file)
--- a/drivers/net/e1000/e1000_hw.c
+++ b/drivers/net/e1000/e1000_hw.c
@@ -144,6 +144,8 @@ static s32 e1000_host_if_read_cookie(struct e1000_hw *hw, u8 *buffer);
 static u8 e1000_calculate_mng_checksum(char *buffer, u32 length);
 static s32 e1000_configure_kmrn_for_10_100(struct e1000_hw *hw, u16 duplex);
 static s32 e1000_configure_kmrn_for_1000(struct e1000_hw *hw);
+static s32 e1000_do_read_eeprom(struct e1000_hw *hw, u16 offset, u16 words, u16 *data);
+static s32 e1000_do_write_eeprom(struct e1000_hw *hw, u16 offset, u16 words, u16 *data);
 
 /* IGP cable length table */
 static const
@@ -168,6 +170,8 @@ u16 e1000_igp_2_cable_length_table[IGP02E1000_AGC_LENGTH_TABLE_SIZE] =
       83, 89, 95, 100, 105, 109, 113, 116, 119, 122, 124,
       104, 109, 114, 118, 121, 124};
 
+static DEFINE_SPINLOCK(e1000_eeprom_lock);
+
 /******************************************************************************
  * Set the phy type member in the hw struct.
  *
@@ -4903,6 +4907,15 @@ static s32 e1000_spi_eeprom_ready(struct e1000_hw *hw)
  * words - number of words to read
  *****************************************************************************/
 s32 e1000_read_eeprom(struct e1000_hw *hw, u16 offset, u16 words, u16 *data)
+{
+    s32 ret;
+    spin_lock(&e1000_eeprom_lock);
+    ret = e1000_do_read_eeprom(hw, offset, words, data);
+    spin_unlock(&e1000_eeprom_lock);
+    return ret;
+}
+
+static s32 e1000_do_read_eeprom(struct e1000_hw *hw, u16 offset, u16 words, u16 *data)
 {
     struct e1000_eeprom_info *eeprom = &hw->eeprom;
     u32 i = 0;
@@ -5235,6 +5248,16 @@ s32 e1000_update_eeprom_checksum(struct e1000_hw *hw)
  * EEPROM will most likely contain an invalid checksum.
  *****************************************************************************/
 s32 e1000_write_eeprom(struct e1000_hw *hw, u16 offset, u16 words, u16 *data)
+{
+    s32 ret;
+    spin_lock(&e1000_eeprom_lock);
+    ret = e1000_do_write_eeprom(hw, offset, words, data);
+    spin_unlock(&e1000_eeprom_lock);
+    return ret;
+}
+
+
+static s32 e1000_do_write_eeprom(struct e1000_hw *hw, u16 offset, u16 words, u16 *data)
 {
     struct e1000_eeprom_info *eeprom = &hw->eeprom;
     s32 status = 0;
@@ -6735,7 +6758,7 @@ static s32 e1000_get_cable_length(struct e1000_hw *hw, u16 *min_length,
  * returns: - E1000_ERR_XXX
  *            E1000_SUCCESS
  *
- * For phy's older then IGP, this function simply reads the polarity bit in the
+ * For phy's older than IGP, this function simply reads the polarity bit in the
  * Phy Status register.  For IGP phy's, this bit is valid only if link speed is
  * 10 Mbps.  If the link speed is 100 Mbps there is no polarity so this bit will
  * return 0.  If the link speed is 1000 Mbps the polarity status is in the
@@ -6811,7 +6834,7 @@ static s32 e1000_check_polarity(struct e1000_hw *hw,
  * returns: - E1000_ERR_XXX
  *            E1000_SUCCESS
  *
- * For phy's older then IGP, this function reads the Downshift bit in the Phy
+ * For phy's older than IGP, this function reads the Downshift bit in the Phy
  * Specific Status register.  For IGP phy's, it reads the Downgrade bit in the
  * Link Health register.  In IGP this bit is latched high, so the driver must
  * read it immediately after link is established.