config MKISS
tristate "Serial port KISS driver"
- depends on AX25 && BROKEN_ON_SMP
+ depends on AX25
+ select CRC16
---help---
KISS is a protocol used for the exchange of data between a computer
and a Terminal Node Controller (a small embedded system commonly
config 6PACK
tristate "Serial port 6PACK driver"
- depends on AX25 && BROKEN_ON_SMP
+ depends on AX25
---help---
6pack is a transmission protocol for the data exchange between your
PC and your TNC (the Terminal Node Controller acts as a kind of
config DMASCC
tristate "High-speed (DMA) SCC driver for AX.25"
- depends on ISA && AX25 && BROKEN_ON_SMP
+ depends on ISA && AX25 && BROKEN_ON_SMP && ISA_DMA_API
---help---
This is a driver for high-speed SCC boards, i.e. those supporting
DMA on one port. You usually use those boards to connect your
dmascc. If you don't pass any parameter to the driver, all
possible I/O addresses are probed. This could irritate other devices
that are currently not in use. You may specify the list of addresses
- to be probed by "dmascc=addr1,addr2,..." (when compiled into the
+ to be probed by "dmascc.io=addr1,addr2,..." (when compiled into the
kernel image) or "io=addr1,addr2,..." (when loaded as a module). The
network interfaces will be called dmascc0 and dmascc1 for the board
detected first, dmascc2 and dmascc3 for the second one, and so on.
config SCC
tristate "Z8530 SCC driver"
- depends on ISA && AX25
+ depends on ISA && AX25 && ISA_DMA_API
---help---
These cards are used to connect your Linux box to an amateur radio
in order to communicate with other computers. If you want to use
config BAYCOM_SER_FDX
tristate "BAYCOM ser12 fullduplex driver for AX.25"
- depends on AX25
+ depends on AX25 && !S390
select CRC_CCITT
---help---
This is one of two drivers for Baycom style simple amateur radio
config BAYCOM_SER_HDX
tristate "BAYCOM ser12 halfduplex driver for AX.25"
- depends on AX25
+ depends on AX25 && !S390
select CRC_CCITT
---help---
This is one of two drivers for Baycom style simple amateur radio
modems that connect to a serial interface. The driver supports the
- ser12 design in full-duplex mode. This is the old driver. It is
+ ser12 design in half-duplex mode. This is the old driver. It is
still provided in case your serial interface chip does not work with
- the full-duplex driver. This driver is depreciated. To configure
+ the full-duplex driver. This driver is deprecated. To configure
the driver, use the sethdlc utility available in the standard ax25
utilities package. For information on the modems, see
<http://www.baycom.de/> and
config YAM
tristate "YAM driver for AX.25"
- depends on AX25
+ depends on AX25 && !S390
help
The YAM is a modem for packet radio which connects to the serial
port and includes some of the functions of a Terminal Node
To compile this driver as a module, choose M here: the module
will be called yam.
+