* a power of 2 number of entries. */
MXGEFW_CMD_SET_INTRQ_SIZE, /* in bytes */
+#define MXGEFW_CMD_SET_INTRQ_SIZE_FLAG_NO_STRICT_SIZE_CHECK (1 << 31)
/* command to bring ethernet interface up. Above parameters
* (plus mtu & mac address) must have been exchanged prior
/* data0, data1 = bus addr,
* data2 = sizeof(struct mcp_irq_data) from driver point of view, allows
* adding new stuff to mcp_irq_data without changing the ABI */
+
+ MXGEFW_CMD_UNALIGNED_TEST,
+ /* same than DMA_TEST (same args) but abort with UNALIGNED on unaligned
+ * chipset */
+
+ MXGEFW_CMD_UNALIGNED_STATUS,
+ /* return data = boolean, true if the chipset is known to be unaligned */
+
+ MXGEFW_CMD_ALWAYS_USE_N_BIG_BUFFERS,
+ /* data0 = number of big buffers to use. It must be 0 or a power of 2.
+ * 0 indicates that the NIC consumes as many buffers as they are required
+ * for packet. This is the default behavior.
+ * A power of 2 number indicates that the NIC always uses the specified
+ * number of buffers for each big receive packet.
+ * It is up to the driver to ensure that this value is big enough for
+ * the NIC to be able to receive maximum-sized packets.
+ */
+
+ MXGEFW_CMD_GET_MAX_RSS_QUEUES,
+ MXGEFW_CMD_ENABLE_RSS_QUEUES,
+ /* data0 = number of slices n (0, 1, ..., n-1) to enable
+ * data1 = interrupt mode.
+ * 0=share one INTx/MSI, 1=use one MSI-X per queue.
+ * If all queues share one interrupt, the driver must have set
+ * RSS_SHARED_INTERRUPT_DMA before enabling queues.
+ */
+#define MXGEFW_SLICE_INTR_MODE_SHARED 0
+#define MXGEFW_SLICE_INTR_MODE_ONE_PER_SLICE 1
+
+ MXGEFW_CMD_GET_RSS_SHARED_INTERRUPT_MASK_OFFSET,
+ MXGEFW_CMD_SET_RSS_SHARED_INTERRUPT_DMA,
+ /* data0, data1 = bus address lsw, msw */
+ MXGEFW_CMD_GET_RSS_TABLE_OFFSET,
+ /* get the offset of the indirection table */
+ MXGEFW_CMD_SET_RSS_TABLE_SIZE,
+ /* set the size of the indirection table */
+ MXGEFW_CMD_GET_RSS_KEY_OFFSET,
+ /* get the offset of the secret key */
+ MXGEFW_CMD_RSS_KEY_UPDATED,
+ /* tell nic that the secret key's been updated */
+ MXGEFW_CMD_SET_RSS_ENABLE,
+ /* data0 = enable/disable rss
+ * 0: disable rss. nic does not distribute receive packets.
+ * 1: enable rss. nic distributes receive packets among queues.
+ * data1 = hash type
+ * 1: IPV4 (required by RSS)
+ * 2: TCP_IPV4 (required by RSS)
+ * 3: IPV4 | TCP_IPV4 (required by RSS)
+ * 4: source port
+ */
+#define MXGEFW_RSS_HASH_TYPE_IPV4 0x1
+#define MXGEFW_RSS_HASH_TYPE_TCP_IPV4 0x2
+#define MXGEFW_RSS_HASH_TYPE_SRC_PORT 0x4
+
+ MXGEFW_CMD_GET_MAX_TSO6_HDR_SIZE,
+ /* Return data = the max. size of the entire headers of a IPv6 TSO packet.
+ * If the header size of a IPv6 TSO packet is larger than the specified
+ * value, then the driver must not use TSO.
+ * This size restriction only applies to IPv6 TSO.
+ * For IPv4 TSO, the maximum size of the headers is fixed, and the NIC
+ * always has enough header buffer to store maximum-sized headers.
+ */
+
+ MXGEFW_CMD_SET_TSO_MODE,
+ /* data0 = TSO mode.
+ * 0: Linux/FreeBSD style (NIC default)
+ * 1: NDIS/NetBSD style
+ */
+#define MXGEFW_TSO_MODE_LINUX 0
+#define MXGEFW_TSO_MODE_NDIS 1
+
+ MXGEFW_CMD_MDIO_READ,
+ /* data0 = dev_addr (PMA/PMD or PCS ...), data1 = register/addr */
+ MXGEFW_CMD_MDIO_WRITE,
+ /* data0 = dev_addr, data1 = register/addr, data2 = value */
+
+ MXGEFW_CMD_XFP_I2C_READ,
+ /* Starts to get a fresh copy of one byte or of the whole xfp i2c table, the
+ * obtained data is cached inside the xaui-xfi chip :
+ * data0 : "all" flag : 0 => get one byte, 1=> get 256 bytes,
+ * data1 : if (data0 == 0): index of byte to refresh [ not used otherwise ]
+ * The operation might take ~1ms for a single byte or ~65ms when refreshing all 256 bytes
+ * During the i2c operation, MXGEFW_CMD_XFP_I2C_READ or MXGEFW_CMD_XFP_BYTE attempts
+ * will return MXGEFW_CMD_ERROR_BUSY
+ */
+ MXGEFW_CMD_XFP_BYTE,
+ /* Return the last obtained copy of a given byte in the xfp i2c table
+ * (copy cached during the last relevant MXGEFW_CMD_XFP_I2C_READ)
+ * data0 : index of the desired table entry
+ * Return data = the byte stored at the requested index in the table
+ */
+
+ MXGEFW_CMD_GET_VPUMP_OFFSET,
+ /* Return data = NIC memory offset of mcp_vpump_public_global */
+ MXGEFW_CMD_RESET_VPUMP,
+ /* Resets the VPUMP state */
+
+ MXGEFW_CMD_SET_RSS_MCP_SLOT_TYPE,
+ /* data0 = mcp_slot type to use.
+ * 0 = the default 4B mcp_slot
+ * 1 = 8B mcp_slot_8
+ */
+#define MXGEFW_RSS_MCP_SLOT_TYPE_MIN 0
+#define MXGEFW_RSS_MCP_SLOT_TYPE_WITH_HASH 1
+
+ MXGEFW_CMD_SET_THROTTLE_FACTOR,
+ /* set the throttle factor for ethp_z8e
+ * data0 = throttle_factor
+ * throttle_factor = 256 * pcie-raw-speed / tx_speed
+ * tx_speed = 256 * pcie-raw-speed / throttle_factor
+ *
+ * For PCI-E x8: pcie-raw-speed == 16Gb/s
+ * For PCI-E x4: pcie-raw-speed == 8Gb/s
+ *
+ * ex1: throttle_factor == 0x1a0 (416), tx_speed == 1.23GB/s == 9.846 Gb/s
+ * ex2: throttle_factor == 0x200 (512), tx_speed == 1.0GB/s == 8 Gb/s
+ *
+ * with tx_boundary == 2048, max-throttle-factor == 8191 => min-speed == 500Mb/s
+ * with tx_boundary == 4096, max-throttle-factor == 4095 => min-speed == 1Gb/s
+ */
+
+ MXGEFW_CMD_VPUMP_UP,
+ /* Allocates VPump Connection, Send Request and Zero copy buffer address tables */
+ MXGEFW_CMD_GET_VPUMP_CLK,
+ /* Get the lanai clock */
+
+ MXGEFW_CMD_GET_DCA_OFFSET,
+ /* offset of dca control for WDMAs */
};
enum myri10ge_mcp_cmd_status {
MXGEFW_CMD_ERROR_HASH_ERROR,
MXGEFW_CMD_ERROR_BAD_PORT,
MXGEFW_CMD_ERROR_RESOURCES,
- MXGEFW_CMD_ERROR_MULTICAST
+ MXGEFW_CMD_ERROR_MULTICAST,
+ MXGEFW_CMD_ERROR_UNALIGNED,
+ MXGEFW_CMD_ERROR_NO_MDIO,
+ MXGEFW_CMD_ERROR_XFP_FAILURE,
+ MXGEFW_CMD_ERROR_XFP_ABSENT,
+ MXGEFW_CMD_ERROR_BAD_PCIE_LINK
};
#define MXGEFW_OLD_IRQ_DATA_LEN 40
struct mcp_irq_data {
/* add new counters at the beginning */
- __be32 future_use[5];
+ __be32 future_use[1];
+ __be32 dropped_pause;
+ __be32 dropped_unicast_filtered;
+ __be32 dropped_bad_crc32;
+ __be32 dropped_bad_phy;
__be32 dropped_multicast_filtered;
/* 40 Bytes */
__be32 send_done_count;
+#define MXGEFW_LINK_DOWN 0
+#define MXGEFW_LINK_UP 1
+#define MXGEFW_LINK_MYRINET 2
+#define MXGEFW_LINK_UNKNOWN 3
__be32 link_up;
__be32 dropped_link_overflow;
__be32 dropped_link_error_or_filtered;
projects / linux-2.6-omap-h63xx.git / blobdiff