sbdma_tx_process(sc,&(sc->sbm_txdma), 0);
if (isr & (M_MAC_INT_CHANNEL << S_MAC_RX_CH0)) {
- if (netif_rx_schedule_prep(&sc->napi)) {
+ if (napi_schedule_prep(&sc->napi)) {
__raw_writeq(0, sc->sbm_imr);
- __netif_rx_schedule(&sc->napi);
+ __napi_schedule(&sc->napi);
/* Depend on the exit from poll to reenable intr */
}
else {
eaddr = sc->sbm_hwaddr;
/*
- * Read the ethernet address. The firwmare left this programmed
+ * Read the ethernet address. The firmware left this programmed
* for us in the ethernet address register for each mac.
*/
return -ENXIO;
}
- phy_dev = phy_connect(dev, phy_dev->dev.bus_id, &sbmac_mii_poll, 0,
+ phy_dev = phy_connect(dev, dev_name(&phy_dev->dev), &sbmac_mii_poll, 0,
PHY_INTERFACE_MODE_GMII);
if (IS_ERR(phy_dev)) {
printk(KERN_ERR "%s: could not attach to PHY\n", dev->name);
pr_info("%s: attached PHY driver [%s] (mii_bus:phy_addr=%s, irq=%d)\n",
dev->name, phy_dev->drv->name,
- phy_dev->dev.bus_id, phy_dev->irq);
+ dev_name(&phy_dev->dev), phy_dev->irq);
sc->phy_dev = phy_dev;
sbdma_tx_process(sc, &(sc->sbm_txdma), 1);
if (work_done < budget) {
- netif_rx_complete(napi);
+ napi_complete(napi);
#ifdef CONFIG_SBMAC_COALESCE
__raw_writeq(((M_MAC_INT_EOP_COUNT | M_MAC_INT_EOP_TIMER) << S_MAC_TX_CH0) |
sbm_base = ioremap_nocache(res->start, res->end - res->start + 1);
if (!sbm_base) {
printk(KERN_ERR "%s: unable to map device registers\n",
- pldev->dev.bus_id);
+ dev_name(&pldev->dev));
err = -ENOMEM;
goto out_out;
}
* If we find a zero, skip this MAC.
*/
sbmac_orig_hwaddr = __raw_readq(sbm_base + R_MAC_ETHERNET_ADDR);
- pr_debug("%s: %sconfiguring MAC at 0x%08Lx\n", pldev->dev.bus_id,
+ pr_debug("%s: %sconfiguring MAC at 0x%08Lx\n", dev_name(&pldev->dev),
sbmac_orig_hwaddr ? "" : "not ", (long long)res->start);
if (sbmac_orig_hwaddr == 0) {
err = 0;
dev = alloc_etherdev(sizeof(struct sbmac_softc));
if (!dev) {
printk(KERN_ERR "%s: unable to allocate etherdev\n",
- pldev->dev.bus_id);
+ dev_name(&pldev->dev));
err = -ENOMEM;
goto out_unmap;
}