[NET] gso: Add skb_is_gso

[linux-2.6-omap-h63xx.git] / drivers / net / spider_net.c

diff --git a/drivers/net/spider_net.c b/drivers/net/spider_net.c
index b36838bfb8dcf77b58b3bf6b9d7e8412743d5132..fb1d5a8a45cf996c47623402b9a406dd7df8fa56 100644 (file)
--- a/drivers/net/spider_net.c
+++ b/drivers/net/spider_net.c
@@ -21,7 +21,6 @@
  * Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
  */
 
-#include <linux/config.h>
 #include <linux/compiler.h>
 #include <linux/crc32.h>
 #include <linux/delay.h>
@@ -1745,7 +1744,7 @@ spider_net_open(struct net_device *netdev)
 
        result = -EBUSY;
        if (request_irq(netdev->irq, spider_net_interrupt,
-                            SA_SHIRQ, netdev->name, netdev))
+                            IRQF_SHARED, netdev->name, netdev))
                goto register_int_failed;
 
        spider_net_enable_card(card);
@@ -1794,15 +1793,7 @@ spider_net_setup_phy(struct spider_net_card *card)
        if (phy->def->ops->setup_forced)
                phy->def->ops->setup_forced(phy, SPEED_1000, DUPLEX_FULL);
 
-       /* the following two writes could be moved to sungem_phy.c */
-       /* enable fiber mode */
-       spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0x9020);
-       /* LEDs active in both modes, autosense prio = fiber */
-       spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0x945f);
-
-       /* switch off fibre autoneg */
-       spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0xfc01);
-       spider_net_write_phy(card->netdev, 1, 0x0b, 0x0004);
+       phy->def->ops->enable_fiber(phy);
 
        phy->def->ops->read_link(phy);
        pr_info("Found %s with %i Mbps, %s-duplex.\n", phy->def->name,