#define DRV_MODULE_NAME "tg3"
#define PFX DRV_MODULE_NAME ": "
-#define DRV_MODULE_VERSION "3.40"
-#define DRV_MODULE_RELDATE "September 15, 2005"
+#define DRV_MODULE_VERSION "3.42"
+#define DRV_MODULE_RELDATE "Oct 3, 2005"
#define TG3_DEF_MAC_MODE 0
#define TG3_DEF_RX_MODE 0
struct tg3 *tp = netdev_priv(dev);
struct tg3_hw_status *sblk = tp->hw_status;
- if (sblk->status & SD_STATUS_UPDATED) {
+ if ((sblk->status & SD_STATUS_UPDATED) ||
+ !(tr32(TG3PCI_PCISTATE) & PCISTATE_INT_NOT_ACTIVE)) {
tw32_mailbox(MAILBOX_INTERRUPT_0 + TG3_64BIT_REG_LOW,
0x00000001);
return IRQ_RETVAL(1);
struct tg3 *tp = netdev_priv(dev);
struct sockaddr *addr = p;
+ if (!is_valid_ether_addr(addr->sa_data))
+ return -EINVAL;
+
memcpy(dev->dev_addr, addr->sa_data, dev->addr_len);
spin_lock_bh(&tp->lock);
}
memset(tp->hw_status, 0, TG3_HW_STATUS_SIZE);
+ if (tp->tg3_flags2 & TG3_FLG2_MII_SERDES) {
+ tp->tg3_flags2 &= ~TG3_FLG2_PARALLEL_DETECT;
+ /* reset to prevent losing 1st rx packet intermittently */
+ tw32_f(MAC_RX_MODE, RX_MODE_RESET);
+ udelay(10);
+ }
+
tp->mac_mode = MAC_MODE_TXSTAT_ENABLE | MAC_MODE_RXSTAT_ENABLE |
MAC_MODE_TDE_ENABLE | MAC_MODE_RDE_ENABLE | MAC_MODE_FHDE_ENABLE;
tw32_f(MAC_MODE, tp->mac_mode | MAC_MODE_RXSTAT_CLEAR | MAC_MODE_TXSTAT_CLEAR);
tw32(MAC_LED_CTRL, tp->led_ctrl);
tw32(MAC_MI_STAT, MAC_MI_STAT_LNKSTAT_ATTN_ENAB);
- if (tp->tg3_flags2 & TG3_FLG2_ANY_SERDES) {
+ if (tp->tg3_flags2 & TG3_FLG2_PHY_SERDES) {
tw32_f(MAC_RX_MODE, RX_MODE_RESET);
udelay(10);
}
if (!netif_running(dev))
return -EAGAIN;
+ if (tp->tg3_flags2 & TG3_FLG2_PHY_SERDES)
+ return -EINVAL;
+
spin_lock_bh(&tp->lock);
r = -EINVAL;
tg3_readphy(tp, MII_BMCR, &bmcr);
if (!tg3_readphy(tp, MII_BMCR, &bmcr) &&
- (bmcr & BMCR_ANENABLE)) {
- tg3_writephy(tp, MII_BMCR, bmcr | BMCR_ANRESTART);
+ ((bmcr & BMCR_ANENABLE) ||
+ (tp->tg3_flags2 & TG3_FLG2_PARALLEL_DETECT))) {
+ tg3_writephy(tp, MII_BMCR, bmcr | BMCR_ANRESTART |
+ BMCR_ANENABLE);
r = 0;
}
spin_unlock_bh(&tp->lock);
struct tg3_rx_buffer_desc *desc;
if (loopback_mode == TG3_MAC_LOOPBACK) {
+ /* HW errata - mac loopback fails in some cases on 5780.
+ * Normal traffic and PHY loopback are not affected by
+ * errata.
+ */
+ if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5780)
+ return 0;
+
mac_mode = (tp->mac_mode & ~MAC_MODE_PORT_MODE_MASK) |
MAC_MODE_PORT_INT_LPBACK | MAC_MODE_LINK_POLARITY |
MAC_MODE_PORT_MODE_GMII;
tw32(MAC_MODE, mac_mode);
} else if (loopback_mode == TG3_PHY_LOOPBACK) {
+ tg3_writephy(tp, MII_BMCR, BMCR_LOOPBACK | BMCR_FULLDPLX |
+ BMCR_SPEED1000);
+ udelay(40);
+ /* reset to prevent losing 1st rx packet intermittently */
+ if (tp->tg3_flags2 & TG3_FLG2_MII_SERDES) {
+ tw32_f(MAC_RX_MODE, RX_MODE_RESET);
+ udelay(10);
+ tw32_f(MAC_RX_MODE, tp->rx_mode);
+ }
mac_mode = (tp->mac_mode & ~MAC_MODE_PORT_MODE_MASK) |
MAC_MODE_LINK_POLARITY | MAC_MODE_PORT_MODE_GMII;
if ((tp->phy_id & PHY_ID_MASK) == PHY_ID_BCM5401)
mac_mode &= ~MAC_MODE_LINK_POLARITY;
tw32(MAC_MODE, mac_mode);
-
- tg3_writephy(tp, MII_BMCR, BMCR_LOOPBACK | BMCR_FULLDPLX |
- BMCR_SPEED1000);
}
else
return -EINVAL;
static struct pci_device_id write_reorder_chipsets[] = {
{ PCI_DEVICE(PCI_VENDOR_ID_AMD,
PCI_DEVICE_ID_AMD_FE_GATE_700C) },
- { PCI_DEVICE(PCI_VENDOR_ID_AMD,
- PCI_DEVICE_ID_AMD_K8_NB) },
+ { PCI_DEVICE(PCI_VENDOR_ID_VIA,
+ PCI_DEVICE_ID_VIA_8385_0) },
{ },
};
u32 misc_ctrl_reg;
tp->tg3_flags2 |= TG3_FLG2_SUN_570X;
#endif
- /* If we have an AMD 762 or K8 chipset, write
- * reordering to the mailbox registers done by the host
- * controller can cause major troubles. We read back from
- * every mailbox register write to force the writes to be
- * posted to the chip in order.
- */
- if (pci_dev_present(write_reorder_chipsets))
- tp->tg3_flags |= TG3_FLAG_MBOX_WRITE_REORDER;
-
/* Force memory write invalidate off. If we leave it on,
* then on 5700_BX chips we have to enable a workaround.
* The workaround is to set the TG3PCI_DMA_RW_CTRL boundary
if (pci_find_capability(tp->pdev, PCI_CAP_ID_EXP) != 0)
tp->tg3_flags2 |= TG3_FLG2_PCI_EXPRESS;
+ /* If we have an AMD 762 or VIA K8T800 chipset, write
+ * reordering to the mailbox registers done by the host
+ * controller can cause major troubles. We read back from
+ * every mailbox register write to force the writes to be
+ * posted to the chip in order.
+ */
+ if (pci_dev_present(write_reorder_chipsets) &&
+ !(tp->tg3_flags2 & TG3_FLG2_PCI_EXPRESS))
+ tp->tg3_flags |= TG3_FLAG_MBOX_WRITE_REORDER;
+
if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5703 &&
tp->pci_lat_timer < 64) {
tp->pci_lat_timer = 64;
};
}
+static char * __devinit tg3_bus_string(struct tg3 *tp, char *str)
+{
+ if (tp->tg3_flags2 & TG3_FLG2_PCI_EXPRESS) {
+ strcpy(str, "PCI Express");
+ return str;
+ } else if (tp->tg3_flags & TG3_FLAG_PCIX_MODE) {
+ u32 clock_ctrl = tr32(TG3PCI_CLOCK_CTRL) & 0x1f;
+
+ strcpy(str, "PCIX:");
+
+ if ((clock_ctrl == 7) ||
+ ((tr32(GRC_MISC_CFG) & GRC_MISC_CFG_BOARD_ID_MASK) ==
+ GRC_MISC_CFG_BOARD_ID_5704CIOBE))
+ strcat(str, "133MHz");
+ else if (clock_ctrl == 0)
+ strcat(str, "33MHz");
+ else if (clock_ctrl == 2)
+ strcat(str, "50MHz");
+ else if (clock_ctrl == 4)
+ strcat(str, "66MHz");
+ else if (clock_ctrl == 6)
+ strcat(str, "100MHz");
+ else if (clock_ctrl == 7)
+ strcat(str, "133MHz");
+ } else {
+ strcpy(str, "PCI:");
+ if (tp->tg3_flags & TG3_FLAG_PCI_HIGH_SPEED)
+ strcat(str, "66MHz");
+ else
+ strcat(str, "33MHz");
+ }
+ if (tp->tg3_flags & TG3_FLAG_PCI_32BIT)
+ strcat(str, ":32-bit");
+ else
+ strcat(str, ":64-bit");
+ return str;
+}
+
static struct pci_dev * __devinit tg3_find_5704_peer(struct tg3 *tp)
{
struct pci_dev *peer;
struct net_device *dev;
struct tg3 *tp;
int i, err, pci_using_dac, pm_cap;
+ char str[40];
if (tg3_version_printed++ == 0)
printk(KERN_INFO "%s", version);
pci_set_drvdata(pdev, dev);
- printk(KERN_INFO "%s: Tigon3 [partno(%s) rev %04x PHY(%s)] (PCI%s:%s:%s) %sBaseT Ethernet ",
+ printk(KERN_INFO "%s: Tigon3 [partno(%s) rev %04x PHY(%s)] (%s) %sBaseT Ethernet ",
dev->name,
tp->board_part_number,
tp->pci_chip_rev_id,
tg3_phy_string(tp),
- ((tp->tg3_flags & TG3_FLAG_PCIX_MODE) ? "X" : ""),
- ((tp->tg3_flags & TG3_FLAG_PCI_HIGH_SPEED) ?
- ((tp->tg3_flags & TG3_FLAG_PCIX_MODE) ? "133MHz" : "66MHz") :
- ((tp->tg3_flags & TG3_FLAG_PCIX_MODE) ? "100MHz" : "33MHz")),
- ((tp->tg3_flags & TG3_FLAG_PCI_32BIT) ? "32-bit" : "64-bit"),
+ tg3_bus_string(tp, str),
(tp->tg3_flags & TG3_FLAG_10_100_ONLY) ? "10/100" : "10/100/1000");
for (i = 0; i < 6; i++)