usb_pipeendpoint(pipe), maxp, period);
}
}
- return 0;
+ return 0;
}
/* Passes this packet up the stack, updating its accounting.
if (netif_running (dev->net)
&& netif_device_present (dev->net)
&& !test_bit (EVENT_RX_HALT, &dev->flags)) {
- switch (retval = usb_submit_urb (urb, GFP_ATOMIC)){
+ switch (retval = usb_submit_urb (urb, GFP_ATOMIC)) {
case -EPIPE:
usbnet_defer_kevent (dev, EVENT_RX_HALT);
break;
entry->urb = NULL;
switch (urb_status) {
- // success
- case 0:
+ /* success */
+ case 0:
if (skb->len < dev->net->hard_header_len) {
entry->state = rx_cleanup;
dev->stats.rx_errors++;
}
break;
- // stalls need manual reset. this is rare ... except that
- // when going through USB 2.0 TTs, unplug appears this way.
- // we avoid the highspeed version of the ETIMEOUT/EILSEQ
- // storm, recovering as needed.
- case -EPIPE:
+ /* stalls need manual reset. this is rare ... except that
+ * when going through USB 2.0 TTs, unplug appears this way.
+ * we avoid the highspeed version of the ETIMEOUT/EILSEQ
+ * storm, recovering as needed.
+ */
+ case -EPIPE:
dev->stats.rx_errors++;
usbnet_defer_kevent (dev, EVENT_RX_HALT);
// FALLTHROUGH
- // software-driven interface shutdown
- case -ECONNRESET: // async unlink
- case -ESHUTDOWN: // hardware gone
+ /* software-driven interface shutdown */
+ case -ECONNRESET: /* async unlink */
+ case -ESHUTDOWN: /* hardware gone */
if (netif_msg_ifdown (dev))
devdbg (dev, "rx shutdown, code %d", urb_status);
goto block;
- // we get controller i/o faults during khubd disconnect() delays.
- // throttle down resubmits, to avoid log floods; just temporarily,
- // so we still recover when the fault isn't a khubd delay.
- case -EPROTO:
- case -ETIME:
- case -EILSEQ:
+ /* we get controller i/o faults during khubd disconnect() delays.
+ * throttle down resubmits, to avoid log floods; just temporarily,
+ * so we still recover when the fault isn't a khubd delay.
+ */
+ case -EPROTO:
+ case -ETIME:
+ case -EILSEQ:
dev->stats.rx_errors++;
if (!timer_pending (&dev->delay)) {
mod_timer (&dev->delay, jiffies + THROTTLE_JIFFIES);
urb = NULL;
break;
- // data overrun ... flush fifo?
- case -EOVERFLOW:
+ /* data overrun ... flush fifo? */
+ case -EOVERFLOW:
dev->stats.rx_over_errors++;
// FALLTHROUGH
- default:
+ default:
entry->state = rx_cleanup;
dev->stats.rx_errors++;
if (netif_msg_rx_err (dev))
int status = urb->status;
switch (status) {
- /* success */
- case 0:
+ /* success */
+ case 0:
dev->driver_info->status(dev, urb);
break;
- /* software-driven interface shutdown */
- case -ENOENT: // urb killed
- case -ESHUTDOWN: // hardware gone
+ /* software-driven interface shutdown */
+ case -ENOENT: /* urb killed */
+ case -ESHUTDOWN: /* hardware gone */
if (netif_msg_ifdown (dev))
devdbg (dev, "intr shutdown, code %d", status);
return;
- /* NOTE: not throttling like RX/TX, since this endpoint
- * already polls infrequently
- */
- default:
+ /* NOTE: not throttling like RX/TX, since this endpoint
+ * already polls infrequently
+ */
+ default:
devdbg (dev, "intr status %d", status);
break;
}
temp = unlink_urbs (dev, &dev->txq) + unlink_urbs (dev, &dev->rxq);
// maybe wait for deletions to finish.
- while (!skb_queue_empty(&dev->rxq) &&
- !skb_queue_empty(&dev->txq) &&
- !skb_queue_empty(&dev->done)) {
+ while (!skb_queue_empty(&dev->rxq)
+ && !skb_queue_empty(&dev->txq)
+ && !skb_queue_empty(&dev->done)) {
msleep(UNLINK_TIMEOUT_MS);
if (netif_msg_ifdown (dev))
devdbg (dev, "waited for %d urb completions", temp);
dev->flags = 0;
del_timer_sync (&dev->delay);
tasklet_kill (&dev->bh);
+ usb_autopm_put_interface(dev->intf);
return 0;
}
static int usbnet_open (struct net_device *net)
{
struct usbnet *dev = netdev_priv(net);
- int retval = 0;
+ int retval;
struct driver_info *info = dev->driver_info;
+ if ((retval = usb_autopm_get_interface(dev->intf)) < 0) {
+ if (netif_msg_ifup (dev))
+ devinfo (dev,
+ "resumption fail (%d) usbnet usb-%s-%s, %s",
+ retval,
+ dev->udev->bus->bus_name, dev->udev->devpath,
+ info->description);
+ goto done_nopm;
+ }
+
// put into "known safe" state
if (info->reset && (retval = info->reset (dev)) < 0) {
if (netif_msg_ifup (dev))
// delay posting reads until we're fully open
tasklet_schedule (&dev->bh);
+ return retval;
done:
+ usb_autopm_put_interface(dev->intf);
+done_nopm:
return retval;
}
* they'll probably want to use this base set.
*/
-#if defined(CONFIG_MII) || defined(CONFIG_MII_MODULE)
-#define HAVE_MII
-
int usbnet_get_settings (struct net_device *net, struct ethtool_cmd *cmd)
{
struct usbnet *dev = netdev_priv(net);
}
EXPORT_SYMBOL_GPL(usbnet_nway_reset);
-#endif /* HAVE_MII */
-
void usbnet_get_drvinfo (struct net_device *net, struct ethtool_drvinfo *info)
{
struct usbnet *dev = netdev_priv(net);
/* drivers may override default ethtool_ops in their bind() routine */
static struct ethtool_ops usbnet_ethtool_ops = {
-#ifdef HAVE_MII
.get_settings = usbnet_get_settings,
.set_settings = usbnet_set_settings,
.get_link = usbnet_get_link,
.nway_reset = usbnet_nway_reset,
-#endif
.get_drvinfo = usbnet_get_drvinfo,
.get_msglevel = usbnet_get_msglevel,
.set_msglevel = usbnet_set_msglevel,
while ((skb = skb_dequeue (&dev->done))) {
entry = (struct skb_data *) skb->cb;
switch (entry->state) {
- case rx_done:
+ case rx_done:
entry->state = rx_cleanup;
rx_process (dev, skb);
continue;
- case tx_done:
- case rx_cleanup:
+ case tx_done:
+ case rx_cleanup:
usb_free_urb (entry->urb);
dev_kfree_skb (skb);
continue;
- default:
+ default:
devdbg (dev, "bogus skb state %d", entry->state);
}
}
struct usb_device *xdev;
int status;
const char *name;
+ DECLARE_MAC_BUF(mac);
name = udev->dev.driver->name;
info = (struct driver_info *) prod->driver_info;
dev = netdev_priv(net);
dev->udev = xdev;
+ dev->intf = udev;
dev->driver_info = info;
dev->driver_name = name;
dev->msg_enable = netif_msg_init (msg_level, NETIF_MSG_DRV
init_timer (&dev->delay);
mutex_init (&dev->phy_mutex);
- SET_MODULE_OWNER (net);
dev->net = net;
strcpy (net->name, "usb%d");
memcpy (net->dev_addr, node_id, sizeof node_id);
if ((dev->driver_info->flags & FLAG_ETHER) != 0
&& (net->dev_addr [0] & 0x02) == 0)
strcpy (net->name, "eth%d");
+ /* WLAN devices should always be named "wlan%d" */
+ if ((dev->driver_info->flags & FLAG_WLAN) != 0)
+ strcpy(net->name, "wlan%d");
/* maybe the remote can't receive an Ethernet MTU */
if (net->mtu > (dev->hard_mtu - net->hard_header_len))
status = 0;
}
- if (status == 0 && dev->status)
+ if (status >= 0 && dev->status)
status = init_status (dev, udev);
if (status < 0)
goto out3;
if (status)
goto out3;
if (netif_msg_probe (dev))
- devinfo (dev, "register '%s' at usb-%s-%s, %s, "
- "%02x:%02x:%02x:%02x:%02x:%02x",
+ devinfo (dev, "register '%s' at usb-%s-%s, %s, %s",
udev->dev.driver->name,
xdev->bus->bus_name, xdev->devpath,
dev->driver_info->description,
- net->dev_addr [0], net->dev_addr [1],
- net->dev_addr [2], net->dev_addr [3],
- net->dev_addr [4], net->dev_addr [5]);
+ print_mac(mac, net->dev_addr));
// ok, it's ready to go.
usb_set_intfdata (udev, dev);
struct usbnet *dev = usb_get_intfdata(intf);
if (!dev->suspend_count++) {
- /* accelerate emptying of the rx and queues, to avoid
+ /*
+ * accelerate emptying of the rx and queues, to avoid
* having everything error out.
*/
netif_device_detach (dev->net);
(void) unlink_urbs (dev, &dev->rxq);
(void) unlink_urbs (dev, &dev->txq);
+ /*
+ * reattach so runtime management can use and
+ * wake the device
+ */
+ netif_device_attach (dev->net);
}
return 0;
}
{
struct usbnet *dev = usb_get_intfdata(intf);
- if (!--dev->suspend_count) {
- netif_device_attach (dev->net);
+ if (!--dev->suspend_count)
tasklet_schedule (&dev->bh);
- }
+
return 0;
}
EXPORT_SYMBOL_GPL(usbnet_resume);
projects / linux-2.6-omap-h63xx.git / blobdiff