iwlwifi: document 4965 rate scaling

[linux-2.6-omap-h63xx.git] / drivers / net / wireless / strip.c

diff --git a/drivers/net/wireless/strip.c b/drivers/net/wireless/strip.c
index c49d5a1f94a27284e67ed9cf7865081d01c6a6da..88efe1bae58f5333d933c93ec21ac0b6aa09c42b 100644 (file)
--- a/drivers/net/wireless/strip.c
+++ b/drivers/net/wireless/strip.c
@@ -1631,8 +1631,8 @@ static void strip_IdleTask(unsigned long parameter)
  */
 
 static int strip_header(struct sk_buff *skb, struct net_device *dev,
-                       unsigned short type, void *daddr, void *saddr,
-                       unsigned len)
+                       unsigned short type, const void *daddr,
+                       const void *saddr, unsigned len)
 {
        struct strip *strip_info = netdev_priv(dev);
        STRIP_Header *header = (STRIP_Header *) skb_push(skb, sizeof(STRIP_Header));
@@ -2497,6 +2497,11 @@ static int strip_close_low(struct net_device *dev)
        return 0;
 }
 
+static const struct header_ops strip_header_ops = {
+       .create = strip_header,
+       .rebuild = strip_rebuild_header,
+};
+
 /*
  * This routine is called by DDI when the
  * (dynamically assigned) device is registered
@@ -2508,8 +2513,6 @@ static void strip_dev_setup(struct net_device *dev)
         * Finish setting up the DEVICE info.
         */
 
-       SET_MODULE_OWNER(dev);
-
        dev->trans_start = 0;
        dev->last_rx = 0;
        dev->tx_queue_len = 30; /* Drop after 30 frames queued */
@@ -2533,8 +2536,8 @@ static void strip_dev_setup(struct net_device *dev)
        dev->open = strip_open_low;
        dev->stop = strip_close_low;
        dev->hard_start_xmit = strip_xmit;
-       dev->hard_header = strip_header;
-       dev->rebuild_header = strip_rebuild_header;
+       dev->header_ops = &strip_header_ops;
+
        dev->set_mac_address = strip_set_mac_address;
        dev->get_stats = strip_get_stats;
        dev->change_mtu = strip_change_mtu;
@@ -2732,16 +2735,8 @@ static int strip_ioctl(struct tty_struct *tty, struct file *file,
                        return -EFAULT;
                return set_mac_address(strip_info, &addr);
        }
-       /*
-        * Allow stty to read, but not set, the serial port
-        */
-
-       case TCGETS:
-       case TCGETA:
-               return n_tty_ioctl(tty, file, cmd, arg);
-               break;
        default:
-               return -ENOIOCTLCMD;
+               return tty_mode_ioctl(tty, file, cmd, arg);
                break;
        }
        return 0;