#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/types.h>
+#include <linux/signal.h>
+#include <linux/jiffies.h>
+#include <linux/timer.h>
#include <linux/pci.h>
+#include <linux/interrupt.h>
+
#include "../pci.h"
#include "pciehp.h"
{
struct php_ctlr_state_s *php_ctlr = slot->ctrl->hpc_ctlr_handle;
u16 slot_cmd;
- u16 slot_ctrl;
+ u16 slot_ctrl, slot_status;
int retval = 0;
return -1;
}
+ /* Clear sticky power-fault bit from previous power failures */
+ hp_register_read_word(php_ctlr->pci_dev,
+ SLOT_STATUS(slot->ctrl->cap_base), slot_status);
+ slot_status &= PWR_FAULT_DETECTED;
+ if (slot_status)
+ hp_register_write_word(php_ctlr->pci_dev,
+ SLOT_STATUS(slot->ctrl->cap_base), slot_status);
+
retval = hp_register_read_word(php_ctlr->pci_dev, SLOT_CTRL(slot->ctrl->cap_base), slot_ctrl);
if (retval) {
slot_cmd = (slot_ctrl & ~PWR_CTRL) | POWER_ON;
+ /* Enable detection that we turned off at slot power-off time */
if (!pciehp_poll_mode)
- slot_cmd = slot_cmd | HP_INTR_ENABLE;
+ slot_cmd = slot_cmd |
+ PWR_FAULT_DETECT_ENABLE |
+ MRL_DETECT_ENABLE |
+ PRSN_DETECT_ENABLE |
+ HP_INTR_ENABLE;
retval = pcie_write_cmd(slot, slot_cmd);
slot_cmd = (slot_ctrl & ~PWR_CTRL) | POWER_OFF;
+ /*
+ * If we get MRL or presence detect interrupts now, the isr
+ * will notice the sticky power-fault bit too and issue power
+ * indicator change commands. This will lead to an endless loop
+ * of command completions, since the power-fault bit remains on
+ * till the slot is powered on again.
+ */
if (!pciehp_poll_mode)
- slot_cmd = slot_cmd | HP_INTR_ENABLE;
+ slot_cmd = (slot_cmd &
+ ~PWR_FAULT_DETECT_ENABLE &
+ ~MRL_DETECT_ENABLE &
+ ~PRSN_DETECT_ENABLE) | HP_INTR_ENABLE;
retval = pcie_write_cmd(slot, slot_cmd);