#include <linux/blkdev.h>
#include <linux/delay.h>
#include <linux/interrupt.h>
+#include <linux/device.h>
#include "scsi.h"
#include <scsi/scsi_host.h>
#include <linux/libata.h>
.remove = ata_pci_remove_one,
};
-static Scsi_Host_Template uli_sht = {
+static struct scsi_host_template uli_sht = {
.module = THIS_MODULE,
.name = DRV_NAME,
.ioctl = ata_scsi_ioctl,
.ordered_flush = 1,
};
-static struct ata_port_operations uli_ops = {
+static const struct ata_port_operations uli_ops = {
.port_disable = ata_port_disable,
.tf_load = ata_tf_load,
uli_scr_cfg_write(ap, sc_reg, val);
}
-/* move to PCI layer, integrate w/ MSI stuff */
-static void pci_enable_intx(struct pci_dev *pdev)
-{
- u16 pci_command;
-
- pci_read_config_word(pdev, PCI_COMMAND, &pci_command);
- if (pci_command & PCI_COMMAND_INTX_DISABLE) {
- pci_command &= ~PCI_COMMAND_INTX_DISABLE;
- pci_write_config_word(pdev, PCI_COMMAND, pci_command);
- }
-}
-
static int uli_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
{
+ static int printed_version;
struct ata_probe_ent *probe_ent;
struct ata_port_info *ppi;
int rc;
unsigned int board_idx = (unsigned int) ent->driver_data;
int pci_dev_busy = 0;
+ if (!printed_version++)
+ dev_printk(KERN_INFO, &pdev->dev, "version " DRV_VERSION "\n");
+
rc = pci_enable_device(pdev);
if (rc)
return rc;
goto err_out_regions;
ppi = &uli_port_info;
- probe_ent = ata_pci_init_native_mode(pdev, &ppi);
+ probe_ent = ata_pci_init_native_mode(pdev, &ppi, ATA_PORT_PRIMARY | ATA_PORT_SECONDARY);
if (!probe_ent) {
rc = -ENOMEM;
goto err_out_regions;
}
pci_set_master(pdev);
- pci_enable_intx(pdev);
+ pci_intx(pdev, 1);
/* FIXME: check ata_device_add return value */
ata_device_add(probe_ent);