work.)
To compile this driver as a module, choose M here: the
- module will be called serial.
+ module will be called 8250.
[WARNING: Do not compile this driver as a module if you are using
non-standard serial ports, since the configuration information will
be lost when the driver is unloaded. This limitation may be lifted
To compile this driver as a module, choose M here: the module
will be called 8250_boca.
-
config SERIAL_8250_HUB6
tristate "Support Hub6 cards"
depends on SERIAL_8250 != n && ISA && SERIAL_8250_MANY_PORTS
your boot loader (lilo or loadlin) about how to pass options to the
kernel at boot time.)
+config SERIAL_AT91
+ bool "AT91RM9200 serial port support"
+ depends on ARM && ARCH_AT91RM9200
+ select SERIAL_CORE
+ help
+ This enables the driver for the on-chip UARTs of the AT91RM9200
+ processor.
+
+config SERIAL_AT91_CONSOLE
+ bool "Support for console on AT91RM9200 serial port"
+ depends on SERIAL_AT91=y
+ select SERIAL_CORE_CONSOLE
+ help
+ Say Y here if you wish to use a UART on the AT91RM9200 as the system
+ console (the system console is the device which receives all kernel
+ messages and warnings and which allows logins in single user mode).
+
+config SERIAL_AT91_TTYAT
+ bool "Install as device ttyAT0-4 instead of ttyS0-4"
+ depends on SERIAL_AT91=y
+ help
+ Say Y here if you wish to have the five internal AT91RM9200 UARTs
+ appear as /dev/ttyAT0-4 (major 204, minor 154-158) instead of the
+ normal /dev/ttyS0-4 (major 4, minor 64-68). This is necessary if
+ you also want other UARTs, such as external 8250/16C550 compatible
+ UARTs.
+ The ttySn nodes are legally reserved for the 8250 serial driver
+ but are often misused by other serial drivers.
+
+ To use this, you should create suitable ttyATn device nodes in
+ /dev/, and pass "console=ttyATn" to the kernel.
+
+ Say Y if you have an external 8250/16C550 UART. If unsure, say N.
+
config SERIAL_CLPS711X
tristate "CLPS711X serial port support"
depends on ARM && ARCH_CLPS711X
config SERIAL_M32R_PLDSIO
bool "M32R SIO I/F on a PLD"
- depends on SERIAL_M32R_SIO=y && (PLAT_OPSPUT || PALT_USRV || PLAT_M32700UT)
+ depends on SERIAL_M32R_SIO=y && (PLAT_OPSPUT || PLAT_USRV || PLAT_M32700UT)
default n
help
Say Y here if you want to use the M32R serial controller
config SERIAL_JSM
tristate "Digi International NEO PCI Support"
- depends on PCI
+ depends on PCI && BROKEN
select SERIAL_CORE
help
This is a driver for Digi International's Neo series
and wish to use the serial ports on this card, say Y.
Otherwise, say N.
+config SERIAL_SGI_IOC3
+ tristate "SGI Altix IOC3 serial support"
+ depends on (IA64_GENERIC || IA64_SGI_SN2) && SGI_IOC3
+ select SERIAL_CORE
+ help
+ If you have an SGI Altix with an IOC3 serial card,
+ say Y or M. Otherwise, say N.
+
endmenu