Input: HID - add support for Logitech Formula Force EX

[linux-2.6-omap-h63xx.git] / drivers / usb / input / Kconfig

diff --git a/drivers/usb/input/Kconfig b/drivers/usb/input/Kconfig
index c7d887540d8d506db46ea65780e090910f28ea25..69a9f3b6d0a9eaedb2d6c63078c02cc57ab0f4e3 100644 (file)
--- a/drivers/usb/input/Kconfig
+++ b/drivers/usb/input/Kconfig
@@ -58,17 +58,29 @@ config HID_PID
          devices.
 
 config LOGITECH_FF
-       bool "Logitech WingMan *3D support"
+       bool "Logitech devices support"
        depends on HID_FF
        select INPUT_FF_MEMLESS if USB_HID
        help
          Say Y here if you have one of these devices:
          - Logitech WingMan Cordless RumblePad
+         - Logitech WingMan Cordless RumblePad 2
          - Logitech WingMan Force 3D
+         - Logitech Formula Force EX
+         - Logitech MOMO Force wheel
+
          and if you want to enable force feedback for them.
          Note: if you say N here, this device will still be supported, but without
          force feedback.
 
+config PANTHERLORD_FF
+       bool "PantherLord USB/PS2 2in1 Adapter support"
+       depends on HID_FF
+       select INPUT_FF_MEMLESS if USB_HID
+       help
+         Say Y here if you have a PantherLord USB/PS2 2in1 Adapter and want
+         to enable force feedback support for it.
+
 config THRUSTMASTER_FF
        bool "ThrustMaster FireStorm Dual Power 2 support (EXPERIMENTAL)"
        depends on HID_FF && EXPERIMENTAL
@@ -344,3 +356,15 @@ config USB_APPLETOUCH
 
          To compile this driver as a module, choose M here: the
          module will be called appletouch.
+
+config USB_GTCO
+        tristate "GTCO CalComp/InterWrite USB Support"
+        depends on USB && INPUT
+        ---help---
+          Say Y here if you want to use the USB version of the GTCO
+          CalComp/InterWrite Tablet.  Make sure to say Y to "Mouse support"
+          (CONFIG_INPUT_MOUSEDEV) and/or "Event interface support"
+          (CONFIG_INPUT_EVDEV) as well.
+
+          To compile this driver as a module, choose M here: the
+          module will be called gtco.