Merge git://git.linux-nfs.org/pub/linux/nfs-2.6

[linux-2.6-omap-h63xx.git] / drivers / usb / storage / Kconfig

diff --git a/drivers/usb/storage/Kconfig b/drivers/usb/storage/Kconfig
index 1a9679f76f5a341be6027551884f44d9c4e6fce0..be9eec2257436c2152aecd9e0d20462f69902b2e 100644 (file)
--- a/drivers/usb/storage/Kconfig
+++ b/drivers/usb/storage/Kconfig
@@ -48,7 +48,8 @@ config USB_STORAGE_FREECOM
 
 config USB_STORAGE_ISD200
        bool "ISD-200 USB/ATA Bridge support"
-       depends on USB_STORAGE && BLK_DEV_IDE
+       depends on USB_STORAGE
+       depends on BLK_DEV_IDE=y || BLK_DEV_IDE=USB_STORAGE
        ---help---
          Say Y here if you want to use USB Mass Store devices based
          on the In-Systems Design ISD-200 USB/ATA bridge.
@@ -112,10 +113,19 @@ config USB_STORAGE_JUMPSHOT
          Say Y here to include additional code to support the Lexar Jumpshot
          USB CompactFlash reader.
 
+config USB_STORAGE_ALAUDA
+       bool "Olympus MAUSB-10/Fuji DPC-R1 support (EXPERIMENTAL)"
+       depends on USB_STORAGE && EXPERIMENTAL
+       help
+         Say Y here to include additional code to support the Olympus MAUSB-10
+         and Fujifilm DPC-R1 USB Card reader/writer devices.
+
+         These devices are based on the Alauda chip and support support both
+         XD and SmartMedia cards.
 
 config USB_STORAGE_ONETOUCH
        bool "Support OneTouch Button on Maxtor Hard Drives (EXPERIMENTAL)"
-       depends on USB_STORAGE && INPUT_EVDEV && EXPERIMENTAL
+       depends on USB_STORAGE && INPUT_EVDEV && EXPERIMENTAL && !PM
        help
          Say Y here to include additional code to support the Maxtor OneTouch
          USB hard drive's onetouch button.
@@ -124,3 +134,17 @@ config USB_STORAGE_ONETOUCH
          hard drive's as an input device. An action can be associated with
          this input in any keybinding software. (e.g. gnome's keyboard short-
          cuts)
+
+config USB_LIBUSUAL
+       bool "The shared table of common (or usual) storage devices"
+       depends on USB
+       help
+         This module contains a table of common (or usual) devices
+         for usb-storage and ub drivers, and allows to switch binding
+         of these devices without rebuilding modules.
+
+         Typical syntax of /etc/modprobe.conf is:
+
+               options libusual bias="ub"
+
+         If unsure, say N.