config FB_CT65550
bool "Chips 65550 display support"
- depends on (FB = y) && PPC32
+ depends on (FB = y) && PPC32 && PCI
select FB_CFB_FILLRECT
select FB_CFB_COPYAREA
select FB_CFB_IMAGEBLIT
help
This is the framebuffer device driver for a SHARP LQ043T1DG01 TFT LCD
+config FB_BFIN_T350MCQB
+ tristate "Varitronix COG-T350MCQB TFT LCD display (BF527 EZKIT)"
+ depends on FB && BLACKFIN
+ select BFIN_GPTIMERS
+ select FB_CFB_FILLRECT
+ select FB_CFB_COPYAREA
+ select FB_CFB_IMAGEBLIT
+ help
+ This is the framebuffer device driver for a Varitronix VL-PS-COG-T350MCQB-01 display TFT LCD
+ This display is a QVGA 320x240 24-bit RGB display interfaced by an 8-bit wide PPI
+ It uses PPI[0..7] PPI_FS1, PPI_FS2 and PPI_CLK.
+
+
config FB_STI
tristate "HP STI frame buffer device support"
depends on FB && PARISC
You will get a boot time penguin logo at no additional cost. Please
read <file:Documentation/fb/vesafb.txt>. If unsure, say Y.
+config FB_EFI
+ bool "EFI-based Framebuffer Support"
+ depends on (FB = y) && X86
+ select FB_CFB_FILLRECT
+ select FB_CFB_COPYAREA
+ select FB_CFB_IMAGEBLIT
+ help
+ This is the EFI frame buffer device driver. If the firmware on
+ your platform is UEFI2.0, select Y to add support for
+ Graphics Output Protocol for early console messages to appear.
+
config FB_IMAC
bool "Intel-based Macintosh Framebuffer Support"
depends on (FB = y) && X86 && EFI
config FB_ATMEL
tristate "AT91/AT32 LCD Controller support"
- depends on FB && (ARCH_AT91SAM9261 || ARCH_AT91SAM9263 || AVR32)
+ depends on FB && (ARCH_AT91SAM9261 || ARCH_AT91SAM9263 || ARCH_AT91SAM9RL || ARCH_AT91CAP9 || AVR32)
select FB_CFB_FILLRECT
select FB_CFB_COPYAREA
select FB_CFB_IMAGEBLIT
WARNING: Do not use any application that uses the 3D engine
(namely glide) while using this driver.
- Please read the <file:Documentation/fb/README-sstfb.txt> for supported
+ Please read the <file:Documentation/fb/sstfb.txt> for supported
options and other important info support.
config FB_VT8623
This driver is also available as a module ( = code which can be
inserted and removed from the running kernel whenever you want). The
module will be called sm501fb. If you want to compile it as a module,
- say M here and read <file:Documentation/modules.txt>.
+ say M here and read <file:Documentation/kbuild/modules.txt>.
If unsure, say N.