unsigned int bios_cyl; /* BIOS/fdisk/LILO number of cyls */
unsigned int cyl; /* "real" number of cyls */
- unsigned int drive_data; /* use by tuneproc/selectproc */
+ unsigned int drive_data; /* used by set_pio_mode/selectproc */
unsigned int failures; /* current failure count */
unsigned int max_failures; /* maximum allowed failure count */
u64 probed_capacity;/* initial reported media capacity (ide-cd only currently) */
#if 0
ide_hwif_ops_t *hwifops;
#else
- /* routine to tune PIO mode for drives */
- void (*tuneproc)(ide_drive_t *, u8);
+ /* routine to set PIO mode for drives */
+ void (*set_pio_mode)(ide_drive_t *, const u8);
/* routine to retune DMA modes for drives */
- int (*speedproc)(ide_drive_t *, u8);
+ int (*speedproc)(ide_drive_t *, const u8);
/* tweaks hardware to select drive */
void (*selectproc)(ide_drive_t *);
/* chipset polling based on hba specifics */
/* driver soft-power interface */
int (*busproc)(ide_drive_t *, int);
#endif
+ u8 (*mdma_filter)(ide_drive_t *);
u8 (*udma_filter)(ide_drive_t *);
void (*ata_input_data)(ide_drive_t *, void *, u32);
*/
extern void ide_fixstring(u8 *, const int, const int);
-/*
- * This routine busy-waits for the drive status to be not "busy".
- * It then checks the status for all of the "good" bits and none
- * of the "bad" bits, and if all is okay it returns 0. All other
- * cases return 1 after doing "*startstop = ide_error()", and the
- * caller should return the updated value of "startstop" in this case.
- * "startstop" is unchanged when the function returns 0;
- * (startstop, drive, good, bad, timeout)
- */
-extern int ide_wait_stat(ide_startstop_t *, ide_drive_t *, u8, u8, unsigned long);
+int ide_wait_stat(ide_startstop_t *, ide_drive_t *, u8, u8, unsigned long);
/*
* Start a reset operation for an IDE interface.
extern void QUIRK_LIST(ide_drive_t *);
extern int drive_is_ready(ide_drive_t *);
-extern int wait_for_ready(ide_drive_t *, int /* timeout */);
/*
* taskfile io for disks for now...and builds request from ide_ioctl
IDE_HFLAG_PIO_NO_BLACKLIST = (1 << 2),
/* don't use conservative PIO "downgrade" */
IDE_HFLAG_PIO_NO_DOWNGRADE = (1 << 3),
+ /* use PIO8/9 for prefetch off/on */
+ IDE_HFLAG_ABUSE_PREFETCH = (1 << 4),
+ /* use PIO6/7 for fast-devsel off/on */
+ IDE_HFLAG_ABUSE_FAST_DEVSEL = (1 << 5),
+ /* use 100-102 and 200-202 PIO values to set DMA modes */
+ IDE_HFLAG_ABUSE_DMA_MODES = (1 << 6),
+ /*
+ * keep DMA setting when programming PIO mode, may be used only
+ * for hosts which have separate PIO and DMA timings (ie. PMAC)
+ */
+ IDE_HFLAG_SET_PIO_MODE_KEEP_DMA = (1 << 7),
};
typedef struct ide_pci_device_s {
#define BAD_DMA_DRIVE 0
#define GOOD_DMA_DRIVE 1
-#ifdef CONFIG_BLK_DEV_IDEDMA
struct drive_list_entry {
const char *id_model;
const char *id_firmware;
};
int ide_in_drive_list(struct hd_driveid *, const struct drive_list_entry *);
+
+#ifdef CONFIG_BLK_DEV_IDEDMA
int __ide_dma_bad_drive(ide_drive_t *);
int __ide_dma_good_drive(ide_drive_t *);
-u8 ide_max_dma_mode(ide_drive_t *);
+
+u8 ide_find_dma_mode(ide_drive_t *, u8);
+
+static inline u8 ide_max_dma_mode(ide_drive_t *drive)
+{
+ return ide_find_dma_mode(drive, XFER_UDMA_6);
+}
+
int ide_tune_dma(ide_drive_t *);
void ide_dma_off(ide_drive_t *);
void ide_dma_verbose(ide_drive_t *);
void ide_dma_off_quietly(ide_drive_t *);
void ide_dma_host_on(ide_drive_t *);
extern int __ide_dma_on(ide_drive_t *);
-extern int __ide_dma_check(ide_drive_t *);
extern int ide_dma_setup(ide_drive_t *);
extern void ide_dma_start(ide_drive_t *);
extern int __ide_dma_end(ide_drive_t *);
#endif /* CONFIG_BLK_DEV_IDEDMA_PCI */
#else
+static inline u8 ide_find_dma_mode(ide_drive_t *drive, u8 speed) { return 0; }
static inline u8 ide_max_dma_mode(ide_drive_t *drive) { return 0; }
static inline int ide_tune_dma(ide_drive_t *drive) { return 0; }
static inline void ide_dma_off(ide_drive_t *drive) { ; }
extern void ide_acpi_get_timing(ide_hwif_t *hwif);
extern void ide_acpi_push_timing(ide_hwif_t *hwif);
extern void ide_acpi_init(ide_hwif_t *hwif);
+extern void ide_acpi_set_state(ide_hwif_t *hwif, int on);
#else
static inline int ide_acpi_exec_tfs(ide_drive_t *drive) { return 0; }
static inline void ide_acpi_get_timing(ide_hwif_t *hwif) { ; }
static inline void ide_acpi_push_timing(ide_hwif_t *hwif) { ; }
static inline void ide_acpi_init(ide_hwif_t *hwif) { ; }
+static inline void ide_acpi_set_state(ide_hwif_t *hwif, int on) {}
#endif
extern int ide_hwif_request_regions(ide_hwif_t *hwif);
}
/* ide-lib.c */
-u8 ide_rate_filter(ide_drive_t *, u8);
extern char *ide_xfer_verbose(u8 xfer_rate);
extern void ide_toggle_bounce(ide_drive_t *drive, int on);
extern int ide_set_xfer_rate(ide_drive_t *drive, u8 rate);
return ((id->field_valid & 2) && (id->capability & 8)) ? 1 : 0;
}
+static inline int ide_dev_is_sata(struct hd_driveid *id)
+{
+ /*
+ * See if word 93 is 0 AND drive is at least ATA-5 compatible
+ * verifying that word 80 by casting it to a signed type --
+ * this trick allows us to filter out the reserved values of
+ * 0x0000 and 0xffff along with the earlier ATA revisions...
+ */
+ if (id->hw_config == 0 && (short)id->major_rev_num >= 0x0020)
+ return 1;
+ return 0;
+}
+
u8 ide_dump_status(ide_drive_t *, const char *, u8);
typedef struct ide_pio_timings_s {
u8 ide_get_best_pio_mode(ide_drive_t *, u8, u8);
extern const ide_pio_timings_t ide_pio_timings[6];
+void ide_set_pio(ide_drive_t *, u8);
+
+static inline void ide_set_max_pio(ide_drive_t *drive)
+{
+ ide_set_pio(drive, 255);
+}
extern spinlock_t ide_lock;
extern struct mutex ide_cfg_mtx;