X-Git-Url: http://pilppa.org/gitweb/gitweb.cgi?a=blobdiff_plain;f=drivers%2Fide%2FKconfig;h=f702f9152ce6992ba91ef2702133f9740d432f54;hb=4880d10927c93d858d40e297361fff375ee98492;hp=87532034d10571818f50d03ff891a6f68b11f17c;hpb=9a64388d83f6ef08dfff405a9d122e3dbcb6bf38;p=linux-2.6-omap-h63xx.git

diff --git a/drivers/ide/Kconfig b/drivers/ide/Kconfig
index 87532034d10..f702f9152ce 100644
--- a/drivers/ide/Kconfig
+++ b/drivers/ide/Kconfig
@@ -862,40 +862,6 @@ config BLK_DEV_IDE_BAST
 	  Say Y here if you want to support the onboard IDE channels on the
 	  Simtec BAST or the Thorcom VR1000
 
-config ETRAX_IDE
-	tristate "ETRAX IDE support"
-	depends on CRIS && BROKEN
-	select BLK_DEV_IDEDMA
-	help
-	  Enables the ETRAX IDE driver.
-
-	  You can't use parallel ports or SCSI ports at the same time.
-
-config ETRAX_IDE_DELAY
-	int "Delay for drives to regain consciousness"
-	depends on ETRAX_IDE && ETRAX_ARCH_V10
-	default 15
-	help
-	  Number of seconds to wait for IDE drives to spin up after an IDE
-	  reset.
-
-choice
-	prompt "IDE reset pin"
-	depends on ETRAX_IDE && ETRAX_ARCH_V10
-	default ETRAX_IDE_PB7_RESET
-
-config ETRAX_IDE_PB7_RESET
-	bool "Port_PB_Bit_7"
-	help
-	  IDE reset on pin 7 on port B
-
-config ETRAX_IDE_G27_RESET
-	bool "Port_G_Bit_27"
-	help
-	  IDE reset on pin 27 on port G
-
-endchoice
-
 config IDE_H8300
 	tristate "H8300 IDE support"
 	depends on H8300
@@ -1031,7 +997,7 @@ comment "Other IDE chipsets support"
 comment "Note: most of these also require special kernel boot parameters"
 
 config BLK_DEV_4DRIVES
-	bool "Generic 4 drives/port support"
+	tristate "Generic 4 drives/port support"
 	help
 	  Certain older chipsets, including the Tekram 690CD, use a single set
 	  of I/O ports at 0x1f0 to control up to four drives, instead of the