X-Git-Url: http://pilppa.org/gitweb/gitweb.cgi?a=blobdiff_plain;f=drivers%2Fnet%2Fspider_net.c;h=fb1d5a8a45cf996c47623402b9a406dd7df8fa56;hb=89114afd435a486deb8583e89f490fc274444d18;hp=1f5975a61e1f1526d8a43869c760ccd96e47753b;hpb=0f36b018b2e314d45af86449f1a97facb1fbe300;p=linux-2.6-omap-h63xx.git

diff --git a/drivers/net/spider_net.c b/drivers/net/spider_net.c
index 1f5975a61e1..fb1d5a8a45c 100644
--- a/drivers/net/spider_net.c
+++ b/drivers/net/spider_net.c
@@ -21,7 +21,6 @@
  * Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
  */
 
-#include <linux/config.h>
 #include <linux/compiler.h>
 #include <linux/crc32.h>
 #include <linux/delay.h>
@@ -1442,7 +1441,7 @@ spider_net_handle_error_irq(struct spider_net_card *card, u32 status_reg)
 	case SPIDER_NET_GRFAFLLINT: /* fallthrough */
 	case SPIDER_NET_GRMFLLINT:
 		if (netif_msg_intr(card) && net_ratelimit())
-			pr_err("Spider RX RAM full, incoming packets "
+			pr_debug("Spider RX RAM full, incoming packets "
 			       "might be discarded!\n");
 		spider_net_rx_irq_off(card);
 		tasklet_schedule(&card->rxram_full_tl);
@@ -1652,6 +1651,8 @@ spider_net_enable_card(struct spider_net_card *card)
 		{ SPIDER_NET_GFTRESTRT, SPIDER_NET_RESTART_VALUE },
 
 		{ SPIDER_NET_GMRWOLCTRL, 0 },
+		{ SPIDER_NET_GTESTMD, 0x10000000 },
+		{ SPIDER_NET_GTTQMSK, 0x00400040 },
 		{ SPIDER_NET_GTESTMD, 0 },
 
 		{ SPIDER_NET_GMACINTEN, 0 },
@@ -1743,7 +1744,7 @@ spider_net_open(struct net_device *netdev)
 
 	result = -EBUSY;
 	if (request_irq(netdev->irq, spider_net_interrupt,
-			     SA_SHIRQ, netdev->name, netdev))
+			     IRQF_SHARED, netdev->name, netdev))
 		goto register_int_failed;
 
 	spider_net_enable_card(card);
@@ -1792,15 +1793,7 @@ spider_net_setup_phy(struct spider_net_card *card)
 	if (phy->def->ops->setup_forced)
 		phy->def->ops->setup_forced(phy, SPEED_1000, DUPLEX_FULL);
 
-	/* the following two writes could be moved to sungem_phy.c */
-	/* enable fiber mode */
-	spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0x9020);
-	/* LEDs active in both modes, autosense prio = fiber */
-	spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0x945f);
-
-	/* switch off fibre autoneg */
-	spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0xfc01);
-	spider_net_write_phy(card->netdev, 1, 0x0b, 0x0004);
+	phy->def->ops->enable_fiber(phy);
 
 	phy->def->ops->read_link(phy);
 	pr_info("Found %s with %i Mbps, %s-duplex.\n", phy->def->name,
@@ -2086,7 +2079,7 @@ spider_net_setup_netdev(struct spider_net_card *card)
 
 	spider_net_setup_netdev_ops(netdev);
 
-	netdev->features = 0;
+	netdev->features = NETIF_F_HW_CSUM;
 	/* some time: NETIF_F_HW_VLAN_TX | NETIF_F_HW_VLAN_RX |
 	 *		NETIF_F_HW_VLAN_FILTER */