X-Git-Url: http://pilppa.org/gitweb/gitweb.cgi?a=blobdiff_plain;f=include%2Flinux%2Fpci_regs.h;h=495d368390e0b00b69b3492ed1ee25338c5c56a6;hb=9b7530c83d04da28fdded741e718721d509c74b1;hp=064b1dc71c228d0edfb29dd18da8477ab445235c;hpb=40b20c257a13c5a526ac540bc5e43d0fdf29792a;p=linux-2.6-omap-h63xx.git diff --git a/include/linux/pci_regs.h b/include/linux/pci_regs.h index 064b1dc71c2..495d368390e 100644 --- a/include/linux/pci_regs.h +++ b/include/linux/pci_regs.h @@ -292,9 +292,11 @@ #define PCI_MSI_DATA_64 12 /* 16 bits of data for 64-bit devices */ #define PCI_MSI_MASK_BIT 16 /* Mask bits register */ -/* MSI-X registers (these are at offset PCI_MSI_FLAGS) */ -#define PCI_MSIX_FLAGS_QSIZE 0x7FF -#define PCI_MSIX_FLAGS_ENABLE (1 << 15) +/* MSI-X registers (these are at offset PCI_MSIX_FLAGS) */ +#define PCI_MSIX_FLAGS 2 +#define PCI_MSIX_FLAGS_QSIZE 0x7FF +#define PCI_MSIX_FLAGS_ENABLE (1 << 15) +#define PCI_MSIX_FLAGS_MASKALL (1 << 14) #define PCI_MSIX_FLAGS_BIRMASK (7 << 0) #define PCI_MSIX_FLAGS_BITMASK (1 << 0) @@ -475,15 +477,32 @@ #define PCI_PWR_CAP 12 /* Capability */ #define PCI_PWR_CAP_BUDGET(x) ((x) & 1) /* Included in system budget */ -/* Hypertransport sub capability types */ +/* + * Hypertransport sub capability types + * + * Unfortunately there are both 3 bit and 5 bit capability types defined + * in the HT spec, catering for that is a little messy. You probably don't + * want to use these directly, just use pci_find_ht_capability() and it + * will do the right thing for you. + */ +#define HT_3BIT_CAP_MASK 0xE0 #define HT_CAPTYPE_SLAVE 0x00 /* Slave/Primary link configuration */ #define HT_CAPTYPE_HOST 0x20 /* Host/Secondary link configuration */ + +#define HT_5BIT_CAP_MASK 0xF8 #define HT_CAPTYPE_IRQ 0x80 /* IRQ Configuration */ #define HT_CAPTYPE_REMAPPING_40 0xA0 /* 40 bit address remapping */ #define HT_CAPTYPE_REMAPPING_64 0xA2 /* 64 bit address remapping */ #define HT_CAPTYPE_UNITID_CLUMP 0x90 /* Unit ID clumping */ #define HT_CAPTYPE_EXTCONF 0x98 /* Extended Configuration Space Access */ #define HT_CAPTYPE_MSI_MAPPING 0xA8 /* MSI Mapping Capability */ +#define HT_MSI_FLAGS 0x02 /* Offset to flags */ +#define HT_MSI_FLAGS_ENABLE 0x1 /* Mapping enable */ +#define HT_MSI_FLAGS_FIXED 0x2 /* Fixed mapping only */ +#define HT_MSI_FIXED_ADDR 0x00000000FEE00000ULL /* Fixed addr */ +#define HT_MSI_ADDR_LO 0x04 /* Offset to low addr bits */ +#define HT_MSI_ADDR_LO_MASK 0xFFF00000 /* Low address bit mask */ +#define HT_MSI_ADDR_HI 0x08 /* Offset to high addr bits */ #define HT_CAPTYPE_DIRECT_ROUTE 0xB0 /* Direct routing configuration */ #define HT_CAPTYPE_VCSET 0xB8 /* Virtual Channel configuration */ #define HT_CAPTYPE_ERROR_RETRY 0xC0 /* Retry on error configuration */