X-Git-Url: http://pilppa.org/gitweb/gitweb.cgi?a=blobdiff_plain;f=include%2Flinux%2FserialP.h;h=2b9e6b9554d577fa49130c4c4e2a4c745d7b3088;hb=ef88b7dba2b47c70037a34a599d383462bb74bd3;hp=2b2f35a64d7510e5436c40bd1ff5caa0b258c7f9;hpb=21d1ee8b375bcd180f1d6b8ccbb8d8f938596310;p=linux-2.6-omap-h63xx.git

diff --git a/include/linux/serialP.h b/include/linux/serialP.h
index 2b2f35a64d7..2b9e6b9554d 100644
--- a/include/linux/serialP.h
+++ b/include/linux/serialP.h
@@ -140,44 +140,4 @@ struct rs_multiport_struct {
 #define ALPHA_KLUDGE_MCR 0
 #endif
 
-/*
- * Definitions for PCI support.
- */
-#define SPCI_FL_BASE_MASK	0x0007
-#define SPCI_FL_BASE0	0x0000
-#define SPCI_FL_BASE1	0x0001
-#define SPCI_FL_BASE2	0x0002
-#define SPCI_FL_BASE3	0x0003
-#define SPCI_FL_BASE4	0x0004
-#define SPCI_FL_GET_BASE(x)	(x & SPCI_FL_BASE_MASK)
-
-#define SPCI_FL_IRQ_MASK       (0x0007 << 4)
-#define SPCI_FL_IRQBASE0       (0x0000 << 4)
-#define SPCI_FL_IRQBASE1       (0x0001 << 4)
-#define SPCI_FL_IRQBASE2       (0x0002 << 4)
-#define SPCI_FL_IRQBASE3       (0x0003 << 4)
-#define SPCI_FL_IRQBASE4       (0x0004 << 4)
-#define SPCI_FL_GET_IRQBASE(x)        ((x & SPCI_FL_IRQ_MASK) >> 4)
-
-/* Use successive BARs (PCI base address registers), 
-   else use offset into some specified BAR */
-#define SPCI_FL_BASE_TABLE	0x0100
-
-/* Use successive entries in the irq resource table */
-#define SPCI_FL_IRQ_TABLE	0x0200
-
-/* Use the irq resource table instead of dev->irq */
-#define SPCI_FL_IRQRESOURCE	0x0400
-
-/* Use the Base address register size to cap number of ports */
-#define SPCI_FL_REGION_SZ_CAP	0x0800
-
-/* Do not use irq sharing for this device */
-#define SPCI_FL_NO_SHIRQ	0x1000
-
-/* This is a PNP device */
-#define SPCI_FL_ISPNP		0x2000
-
-#define SPCI_FL_PNPDEFAULT	(SPCI_FL_IRQRESOURCE|SPCI_FL_ISPNP)
-
 #endif /* _LINUX_SERIAL_H */