X-Git-Url: http://pilppa.org/gitweb/gitweb.cgi?a=blobdiff_plain;f=kernel%2Fpower%2Fmain.c;h=0b7476f5d2a64fc848b88bfc51a06eb8d233eae1;hb=a2e2e3577c3ef2b5dbb866e97e612aae4adfa32f;hp=3398f4651aa150b370a6eeef95305ca56ff39a0b;hpb=acee709cab689ec7703770e8b8cb5cc3a4abcb31;p=linux-2.6-omap-h63xx.git diff --git a/kernel/power/main.c b/kernel/power/main.c index 3398f4651aa..0b7476f5d2a 100644 --- a/kernel/power/main.c +++ b/kernel/power/main.c @@ -132,6 +132,61 @@ static inline int suspend_test(int level) { return 0; } #ifdef CONFIG_SUSPEND +#ifdef CONFIG_PM_TEST_SUSPEND + +/* + * We test the system suspend code by setting an RTC wakealarm a short + * time in the future, then suspending. Suspending the devices won't + * normally take long ... some systems only need a few milliseconds. + * + * The time it takes is system-specific though, so when we test this + * during system bootup we allow a LOT of time. + */ +#define TEST_SUSPEND_SECONDS 5 + +static unsigned long suspend_test_start_time; + +static void suspend_test_start(void) +{ + /* FIXME Use better timebase than "jiffies", ideally a clocksource. + * What we want is a hardware counter that will work correctly even + * during the irqs-are-off stages of the suspend/resume cycle... + */ + suspend_test_start_time = jiffies; +} + +static void suspend_test_finish(const char *label) +{ + long nj = jiffies - suspend_test_start_time; + unsigned msec; + + msec = jiffies_to_msecs(abs(nj)); + pr_info("PM: %s took %d.%03d seconds\n", label, + msec / 1000, msec % 1000); + + /* Warning on suspend means the RTC alarm period needs to be + * larger -- the system was sooo slooowwww to suspend that the + * alarm (should have) fired before the system went to sleep! + * + * Warning on either suspend or resume also means the system + * has some performance issues. The stack dump of a WARN_ON + * is more likely to get the right attention than a printk... + */ + WARN_ON(msec > (TEST_SUSPEND_SECONDS * 1000)); +} + +#else + +static void suspend_test_start(void) +{ +} + +static void suspend_test_finish(const char *label) +{ +} + +#endif + /* This is just an arbitrary number */ #define FREE_PAGE_NUMBER (100) @@ -266,12 +321,13 @@ int suspend_devices_and_enter(suspend_state_t state) goto Close; } suspend_console(); + suspend_test_start(); error = device_suspend(PMSG_SUSPEND); if (error) { printk(KERN_ERR "PM: Some devices failed to suspend\n"); goto Recover_platform; } - + suspend_test_finish("suspend devices"); if (suspend_test(TEST_DEVICES)) goto Recover_platform; @@ -293,7 +349,9 @@ int suspend_devices_and_enter(suspend_state_t state) if (suspend_ops->finish) suspend_ops->finish(); Resume_devices: + suspend_test_start(); device_resume(PMSG_RESUME); + suspend_test_finish("resume devices"); resume_console(); Close: if (suspend_ops->end) @@ -521,3 +579,144 @@ static int __init pm_init(void) } core_initcall(pm_init); + + +#ifdef CONFIG_PM_TEST_SUSPEND + +#include + +/* + * To test system suspend, we need a hands-off mechanism to resume the + * system. RTCs wake alarms are a common self-contained mechanism. + */ + +static void __init test_wakealarm(struct rtc_device *rtc, suspend_state_t state) +{ + static char err_readtime[] __initdata = + KERN_ERR "PM: can't read %s time, err %d\n"; + static char err_wakealarm [] __initdata = + KERN_ERR "PM: can't set %s wakealarm, err %d\n"; + static char err_suspend[] __initdata = + KERN_ERR "PM: suspend test failed, error %d\n"; + static char info_test[] __initdata = + KERN_INFO "PM: test RTC wakeup from '%s' suspend\n"; + + unsigned long now; + struct rtc_wkalrm alm; + int status; + + /* this may fail if the RTC hasn't been initialized */ + status = rtc_read_time(rtc, &alm.time); + if (status < 0) { + printk(err_readtime, rtc->dev.bus_id, status); + return; + } + rtc_tm_to_time(&alm.time, &now); + + memset(&alm, 0, sizeof alm); + rtc_time_to_tm(now + TEST_SUSPEND_SECONDS, &alm.time); + alm.enabled = true; + + status = rtc_set_alarm(rtc, &alm); + if (status < 0) { + printk(err_wakealarm, rtc->dev.bus_id, status); + return; + } + + if (state == PM_SUSPEND_MEM) { + printk(info_test, pm_states[state]); + status = pm_suspend(state); + if (status == -ENODEV) + state = PM_SUSPEND_STANDBY; + } + if (state == PM_SUSPEND_STANDBY) { + printk(info_test, pm_states[state]); + status = pm_suspend(state); + } + if (status < 0) + printk(err_suspend, status); + + /* Some platforms can't detect that the alarm triggered the + * wakeup, or (accordingly) disable it after it afterwards. + * It's supposed to give oneshot behavior; cope. + */ + alm.enabled = false; + rtc_set_alarm(rtc, &alm); +} + +static int __init has_wakealarm(struct device *dev, void *name_ptr) +{ + struct rtc_device *candidate = to_rtc_device(dev); + + if (!candidate->ops->set_alarm) + return 0; + if (!device_may_wakeup(candidate->dev.parent)) + return 0; + + *(char **)name_ptr = dev->bus_id; + return 1; +} + +/* + * Kernel options like "test_suspend=mem" force suspend/resume sanity tests + * at startup time. They're normally disabled, for faster boot and because + * we can't know which states really work on this particular system. + */ +static suspend_state_t test_state __initdata = PM_SUSPEND_ON; + +static char warn_bad_state[] __initdata = + KERN_WARNING "PM: can't test '%s' suspend state\n"; + +static int __init setup_test_suspend(char *value) +{ + unsigned i; + + /* "=mem" ==> "mem" */ + value++; + for (i = 0; i < PM_SUSPEND_MAX; i++) { + if (!pm_states[i]) + continue; + if (strcmp(pm_states[i], value) != 0) + continue; + test_state = (__force suspend_state_t) i; + return 0; + } + printk(warn_bad_state, value); + return 0; +} +__setup("test_suspend", setup_test_suspend); + +static int __init test_suspend(void) +{ + static char warn_no_rtc[] __initdata = + KERN_WARNING "PM: no wakealarm-capable RTC driver is ready\n"; + + char *pony = NULL; + struct rtc_device *rtc = NULL; + + /* PM is initialized by now; is that state testable? */ + if (test_state == PM_SUSPEND_ON) + goto done; + if (!valid_state(test_state)) { + printk(warn_bad_state, pm_states[test_state]); + goto done; + } + + /* RTCs have initialized by now too ... can we use one? */ + class_find_device(rtc_class, NULL, &pony, has_wakealarm); + if (pony) + rtc = rtc_class_open(pony); + if (!rtc) { + printk(warn_no_rtc); + goto done; + } + + /* go for it */ + test_wakealarm(rtc, test_state); + rtc_class_close(rtc); +done: + return 0; +} +late_initcall(test_suspend); + +#endif /* CONFIG_PM_TEST_SUSPEND */