return retval;
 }
 
+void usb_enable_root_hub_irq (struct usb_bus *bus)
+{
+       struct usb_hcd *hcd;
+
+       hcd = container_of (bus, struct usb_hcd, self);
+       if (hcd->driver->hub_irq_enable && hcd->state != HC_STATE_HALT)
+               hcd->driver->hub_irq_enable (hcd);
+}
+
 
 /*-------------------------------------------------------------------------*/
 
 
        int     (*bus_suspend)(struct usb_hcd *);
        int     (*bus_resume)(struct usb_hcd *);
        int     (*start_port_reset)(struct usb_hcd *, unsigned port_num);
+       void    (*hub_irq_enable)(struct usb_hcd *);
+               /* Needed only if port-change IRQs are level-triggered */
 
                /* force handover of high-speed port to full-speed companion */
        void    (*relinquish_port)(struct usb_hcd *, int);
 
        }
 
        clear_bit(port1, hub->busy_bits);
+       if (!hub->hdev->parent && !hub->busy_bits[0])
+               usb_enable_root_hub_irq(hub->hdev->bus);
 
        if (status == 0)
                status = finish_port_resume(udev);
 
                hub->activating = 0;
 
+               /* If this is a root hub, tell the HCD it's okay to
+                * re-enable port-change interrupts now. */
+               if (!hdev->parent && !hub->busy_bits[0])
+                       usb_enable_root_hub_irq(hdev->bus);
+
 loop_autopm:
                /* Allow autosuspend if we're not going to run again */
                if (list_empty(&hub->event_list))
                        break;
        }
        clear_bit(port1, parent_hub->busy_bits);
+       if (!parent_hdev->parent && !parent_hub->busy_bits[0])
+               usb_enable_root_hub_irq(parent_hdev->bus);
 
        if (ret < 0)
                goto re_enumerate;
 
         */
        .hub_status_data =      ohci_hub_status_data,
        .hub_control =          ohci_hub_control,
+       .hub_irq_enable =       ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend =          ohci_bus_suspend,
        .bus_resume =           ohci_bus_resume,
 
         */
        .hub_status_data =      ohci_hub_status_data,
        .hub_control =          ohci_hub_control,
+       .hub_irq_enable =       ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend =          ohci_bus_suspend,
        .bus_resume =           ohci_bus_resume,
 
        .get_frame_number       = ohci_get_frame,
        .hub_status_data        = ohci_hub_status_data,
        .hub_control            = ohci_hub_control,
+       .hub_irq_enable         = ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend            = ohci_bus_suspend,
        .bus_resume             = ohci_bus_resume,
 
 
 /*-------------------------------------------------------------------------*/
 
+/* hcd->hub_irq_enable() */
+static void ohci_rhsc_enable (struct usb_hcd *hcd)
+{
+       struct ohci_hcd         *ohci = hcd_to_ohci (hcd);
+
+       spin_lock_irq(&ohci->lock);
+       if (!ohci->autostop)
+               del_timer(&hcd->rh_timer);      /* Prevent next poll */
+       ohci_writel(ohci, OHCI_INTR_RHSC, &ohci->regs->intrenable);
+       spin_unlock_irq(&ohci->lock);
+}
+
 #define OHCI_SCHED_ENABLES \
        (OHCI_CTRL_CLE|OHCI_CTRL_BLE|OHCI_CTRL_PLE|OHCI_CTRL_IE)
 
                int any_connected)
 {
        int     poll_rh = 1;
-       int     rhsc;
 
-       rhsc = ohci_readl(ohci, &ohci->regs->intrenable) & OHCI_INTR_RHSC;
        switch (ohci->hc_control & OHCI_CTRL_HCFS) {
 
        case OHCI_USB_OPER:
-               /* If no status changes are pending, enable status-change
-                * interrupts.
-                */
-               if (!rhsc && !changed) {
-                       rhsc = OHCI_INTR_RHSC;
-                       ohci_writel(ohci, rhsc, &ohci->regs->intrenable);
-               }
-
-               /* Keep on polling until we know a device is connected
-                * and RHSC is enabled, or until we autostop.
-                */
+               /* keep on polling until we know a device is connected
+                * and RHSC is enabled */
                if (!ohci->autostop) {
                        if (any_connected ||
                                        !device_may_wakeup(&ohci_to_hcd(ohci)
                                                ->self.root_hub->dev)) {
-                               if (rhsc)
+                               if (ohci_readl(ohci, &ohci->regs->intrenable) &
+                                               OHCI_INTR_RHSC)
                                        poll_rh = 0;
                        } else {
                                ohci->autostop = 1;
                                ohci->autostop = 0;
                                ohci->next_statechange = jiffies +
                                                STATECHANGE_DELAY;
-                       } else if (rhsc && time_after_eq(jiffies,
+                       } else if (time_after_eq(jiffies,
                                                ohci->next_statechange)
                                        && !ohci->ed_rm_list
                                        && !(ohci->hc_control &
                                                OHCI_SCHED_ENABLES)) {
                                ohci_rh_suspend(ohci, 1);
-                               poll_rh = 0;
                        }
                }
                break;
                        else
                                usb_hcd_resume_root_hub(ohci_to_hcd(ohci));
                } else {
-                       if (!rhsc && (ohci->autostop ||
-                                       ohci_to_hcd(ohci)->self.root_hub->
-                                               do_remote_wakeup))
-                               ohci_writel(ohci, OHCI_INTR_RHSC,
-                                               &ohci->regs->intrenable);
-
                        /* everything is idle, no need for polling */
                        poll_rh = 0;
                }
 static int ohci_root_hub_state_changes(struct ohci_hcd *ohci, int changed,
                int any_connected)
 {
-       /* If RHSC is enabled, don't poll */
-       if (ohci_readl(ohci, &ohci->regs->intrenable) & OHCI_INTR_RHSC)
-               return 0;
+       int     poll_rh = 1;
 
-       /* If no status changes are pending, enable status-change interrupts */
-       if (!changed) {
-               ohci_writel(ohci, OHCI_INTR_RHSC, &ohci->regs->intrenable);
-               return 0;
-       }
-       return 1;
+       /* keep on polling until RHSC is enabled */
+       if (ohci_readl(ohci, &ohci->regs->intrenable) & OHCI_INTR_RHSC)
+               poll_rh = 0;
+       return poll_rh;
 }
 
 #endif /* CONFIG_PM */
 
         */
        .hub_status_data =      ohci_hub_status_data,
        .hub_control =          ohci_hub_control,
+       .hub_irq_enable =       ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend =          ohci_bus_suspend,
        .bus_resume =           ohci_bus_resume,
 
         */
        .hub_status_data =      ohci_hub_status_data,
        .hub_control =          ohci_hub_control,
+       .hub_irq_enable =       ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend =          ohci_bus_suspend,
        .bus_resume =           ohci_bus_resume,
 
         */
        .hub_status_data =      ohci_hub_status_data,
        .hub_control =          ohci_hub_control,
+       .hub_irq_enable =       ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend =          ohci_bus_suspend,
        .bus_resume =           ohci_bus_resume,
 
         */
        .hub_status_data = ohci_hub_status_data,
        .hub_control = ohci_hub_control,
+       .hub_irq_enable = ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend = ohci_bus_suspend,
        .bus_resume = ohci_bus_resume,
 
         */
        .hub_status_data =      ohci_hub_status_data,
        .hub_control =          ohci_hub_control,
+       .hub_irq_enable =       ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend =          ohci_bus_suspend,
        .bus_resume =           ohci_bus_resume,
 
         */
        .hub_status_data =      ohci_hub_status_data,
        .hub_control =          ohci_hub_control,
+       .hub_irq_enable =       ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend =          ohci_bus_suspend,
        .bus_resume =           ohci_bus_resume,
 
         */
        .hub_status_data =      ohci_hub_status_data,
        .hub_control =          ohci_hub_control,
+       .hub_irq_enable =       ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend =          ohci_bus_suspend,
        .bus_resume =           ohci_bus_resume,
 
        .get_frame_number       = ohci_get_frame,
        .hub_status_data        = ohci_hub_status_data,
        .hub_control            = ohci_hub_control,
+       .hub_irq_enable         = ohci_rhsc_enable,
        .start_port_reset       = ohci_start_port_reset,
 #if defined(CONFIG_PM)
        .bus_suspend            = ohci_bus_suspend,
 
         */
        .hub_status_data =      ohci_hub_status_data,
        .hub_control =          ohci_hub_control,
+       .hub_irq_enable =       ohci_rhsc_enable,
 #ifdef  CONFIG_PM
        .bus_suspend =          ohci_bus_suspend,
        .bus_resume =           ohci_bus_resume,
 
         */
        .hub_status_data =      ohci_s3c2410_hub_status_data,
        .hub_control =          ohci_s3c2410_hub_control,
+       .hub_irq_enable =       ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend =          ohci_bus_suspend,
        .bus_resume =           ohci_bus_resume,
 
         */
        .hub_status_data =      ohci_hub_status_data,
        .hub_control =          ohci_hub_control,
+       .hub_irq_enable =       ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend =          ohci_bus_suspend,
        .bus_resume =           ohci_bus_resume,
 
         */
        .hub_status_data =      ohci_hub_status_data,
        .hub_control =          ohci_hub_control,
+       .hub_irq_enable =       ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend =          ohci_bus_suspend,
        .bus_resume =           ohci_bus_resume,
 
         */
        .hub_status_data =      ohci_hub_status_data,
        .hub_control =          ohci_hub_control,
+       .hub_irq_enable =       ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend =          ohci_bus_suspend,
        .bus_resume =           ohci_bus_resume,
 
 
        .hub_status_data        = ohci_hub_status_data,
        .hub_control            = ohci_hub_control,
+       .hub_irq_enable         = ohci_rhsc_enable,
 #ifdef CONFIG_PM
        .bus_suspend            = ohci_bus_suspend,
        .bus_resume             = ohci_bus_resume,
 
                return 0;
 }
 
+static void u132_hub_irq_enable(struct usb_hcd *hcd)
+{
+       struct u132 *u132 = hcd_to_u132(hcd);
+       if (u132->going > 1) {
+               dev_err(&u132->platform_dev->dev, "device has been removed %d\n"
+                       , u132->going);
+       } else if (u132->going > 0)
+               dev_err(&u132->platform_dev->dev, "device is being removed\n");
+}
+
 
 #ifdef CONFIG_PM
 static int u132_bus_suspend(struct usb_hcd *hcd)
        .bus_suspend = u132_bus_suspend,
        .bus_resume = u132_bus_resume,
        .start_port_reset = u132_start_port_reset,
+       .hub_irq_enable = u132_hub_irq_enable,
 };
 
 /*