From a617c09f6d646b60f31efc8afd9f81b752bf21b7 Mon Sep 17 00:00:00 2001 From: Jeff Garzik Date: Mon, 21 May 2007 20:14:23 -0400 Subject: [PATCH] libata: Trim trailing whitespace Signed-off-by: Jeff Garzik --- drivers/ata/Kconfig | 2 +- drivers/ata/libata-core.c | 8 ++++---- drivers/ata/libata-eh.c | 2 +- drivers/ata/pata_artop.c | 2 +- drivers/ata/pata_cmd640.c | 4 ++-- drivers/ata/pata_hpt37x.c | 10 +++++----- drivers/ata/sata_nv.c | 4 ++-- drivers/ata/sata_sil.c | 2 +- 8 files changed, 17 insertions(+), 17 deletions(-) diff --git a/drivers/ata/Kconfig b/drivers/ata/Kconfig index ad1f59c1b3f..b4a8d6030e4 100644 --- a/drivers/ata/Kconfig +++ b/drivers/ata/Kconfig @@ -132,7 +132,7 @@ config SATA_SIS depends on PCI select PATA_SIS help - This option enables support for SiS Serial ATA on + This option enables support for SiS Serial ATA on SiS 964/965/966/180 and Parallel ATA on SiS 180. The PATA support for SiS 180 requires additionally to enable the PATA_SIS driver in the config. diff --git a/drivers/ata/libata-core.c b/drivers/ata/libata-core.c index c809619d23c..94f339e34f1 100644 --- a/drivers/ata/libata-core.c +++ b/drivers/ata/libata-core.c @@ -977,7 +977,7 @@ static u64 ata_hpa_resize(struct ata_device *dev) { u64 sectors = dev->n_sectors; u64 hpa_sectors; - + if (ata_id_has_lba48(dev->id)) hpa_sectors = ata_read_native_max_address_ext(dev); else @@ -1588,7 +1588,7 @@ unsigned int ata_do_simple_cmd(struct ata_device *dev, u8 cmd) * Check if the current speed of the device requires IORDY. Used * by various controllers for chip configuration. */ - + unsigned int ata_pio_need_iordy(const struct ata_device *adev) { /* Controller doesn't support IORDY. Probably a pointless check @@ -1611,7 +1611,7 @@ unsigned int ata_pio_need_iordy(const struct ata_device *adev) * Compute the highest mode possible if we are not using iordy. Return * -1 if no iordy mode is available. */ - + static u32 ata_pio_mask_no_iordy(const struct ata_device *adev) { /* If we have no drive specific rule, then PIO 2 is non IORDY */ @@ -2663,7 +2663,7 @@ int ata_timing_compute(struct ata_device *adev, unsigned short speed, t->active += (t->cycle - (t->active + t->recover)) / 2; t->recover = t->cycle - t->active; } - + /* In a few cases quantisation may produce enough errors to leave t->cycle too low for the sum of active and recovery if so we must correct this */ diff --git a/drivers/ata/libata-eh.c b/drivers/ata/libata-eh.c index 5309c312f51..d8070989a39 100644 --- a/drivers/ata/libata-eh.c +++ b/drivers/ata/libata-eh.c @@ -1009,7 +1009,7 @@ static unsigned int atapi_eh_request_sense(struct ata_queued_cmd *qc) sense_buf[0] = 0x70; sense_buf[2] = qc->result_tf.feature >> 4; - /* some devices time out if garbage left in tf */ + /* some devices time out if garbage left in tf */ ata_tf_init(dev, &tf); memset(cdb, 0, ATAPI_CDB_LEN); diff --git a/drivers/ata/pata_artop.c b/drivers/ata/pata_artop.c index 9861059dd67..c60e7a04a71 100644 --- a/drivers/ata/pata_artop.c +++ b/drivers/ata/pata_artop.c @@ -99,7 +99,7 @@ static int artop6260_pre_reset(struct ata_port *ap, unsigned long deadline) * * Identify the cable type for the ARTOp interface in question */ - + static int artop6260_cable_detect(struct ata_port *ap) { struct pci_dev *pdev = to_pci_dev(ap->host->dev); diff --git a/drivers/ata/pata_cmd640.c b/drivers/ata/pata_cmd640.c index ed00fa9d53b..31cbf8daa29 100644 --- a/drivers/ata/pata_cmd640.c +++ b/drivers/ata/pata_cmd640.c @@ -107,7 +107,7 @@ static void cmd640_set_piomode(struct ata_port *ap, struct ata_device *adev) pci_write_config_byte(pdev, arttim + 1, (t.active << 4) | t.recover); } else { /* Save the shared timings for channel, they will be loaded - by qc_issue_prot. Reloading the setup time is expensive + by qc_issue_prot. Reloading the setup time is expensive so we keep a merged one loaded */ pci_read_config_byte(pdev, ARTIM23, ®); reg &= 0x3F; @@ -231,7 +231,7 @@ static void cmd640_hardware_init(struct pci_dev *pdev) pci_write_config_byte(pdev, CMDTIM, 0); /* 512 byte bursts (sector) */ pci_write_config_byte(pdev, BRST, 0x40); - /* + /* * A reporter a long time ago * Had problems with the data fifo * So don't run the risk diff --git a/drivers/ata/pata_hpt37x.c b/drivers/ata/pata_hpt37x.c index 5a0a410654e..a54c17433ee 100644 --- a/drivers/ata/pata_hpt37x.c +++ b/drivers/ata/pata_hpt37x.c @@ -961,7 +961,7 @@ static int hpt37x_init_one(struct pci_dev *dev, const struct pci_device_id *id) u8 mcr1; u32 freq; int prefer_dpll = 1; - + unsigned long iobase = pci_resource_start(dev, 4); const struct hpt_chip *chip_table; @@ -1055,7 +1055,7 @@ static int hpt37x_init_one(struct pci_dev *dev, const struct pci_device_id *id) */ pci_write_config_byte(dev, 0x5b, 0x23); - + /* * HighPoint does this for HPT372A. * NOTE: This register is only writeable via I/O space. @@ -1088,7 +1088,7 @@ static int hpt37x_init_one(struct pci_dev *dev, const struct pci_device_id *id) * Turn the frequency check into a band and then find a timing * table to match it. */ - + clock_slot = hpt37x_clock_slot(freq, chip_table->base); if (chip_table->clocks[clock_slot] == NULL || prefer_dpll) { /* @@ -1099,11 +1099,11 @@ static int hpt37x_init_one(struct pci_dev *dev, const struct pci_device_id *id) */ unsigned int f_low, f_high; int adjust; - + clock_slot = 2; if (port->udma_mask & 0xE0) clock_slot = 3; - + f_low = (MHz[clock_slot] * chip_table->base) / 192; f_high = f_low + 2; diff --git a/drivers/ata/sata_nv.c b/drivers/ata/sata_nv.c index 1a49c777fa6..885357b8c93 100644 --- a/drivers/ata/sata_nv.c +++ b/drivers/ata/sata_nv.c @@ -802,7 +802,7 @@ static irqreturn_t nv_adma_interrupt(int irq, void *dev_instance) u16 status; u32 gen_ctl; u32 notifier, notifier_error; - + /* if ADMA is disabled, use standard ata interrupt handler */ if (pp->flags & NV_ADMA_ATAPI_SETUP_COMPLETE) { u8 irq_stat = readb(host->iomap[NV_MMIO_BAR] + NV_INT_STATUS_CK804) @@ -963,7 +963,7 @@ static void nv_adma_irq_clear(struct ata_port *ap) /* clear ADMA status */ writew(0xffff, mmio + NV_ADMA_STAT); - + /* clear notifiers - note both ports need to be written with something even though we are only clearing on one */ if (ap->port_no == 0) { diff --git a/drivers/ata/sata_sil.c b/drivers/ata/sata_sil.c index e8483aadd11..a3b339bcf3c 100644 --- a/drivers/ata/sata_sil.c +++ b/drivers/ata/sata_sil.c @@ -305,7 +305,7 @@ static int sil_set_mode (struct ata_port *ap, struct ata_device **r_failed) u32 tmp, dev_mode[2]; unsigned int i; int rc; - + rc = ata_do_set_mode(ap, r_failed); if (rc) return rc; -- 2.41.1